XP AJ3010/00 20-06-2000 16:33 Pagina 5
INSTALLATION
POWER SUPPLY AND DEMO MODEPOWER BREAKDOWN BACKUP
1. Check if the mains voltage, shown on the type plate on theWhen the mains power fail, the complete clock radio will be
bottom of the set, corresponds to your local mains supply. Ifswitched off. When the mains supply returns, the display will
Englishit does not, consult your dealer or service centre.show the PHILIPS demo mode and the correct clock time
2. Connect the mains plug into the wall socket. The mainshas to be set again.
supply is now switched on and the display will show the
PHILIPS demo mode. To retain the clock time and the set alarm time in the event of
" PH..IL..IPS scrolls across the display continuously.an AC mains failure or disconnection, insert two 1.5V
Y Press the TIME SET to exit the demo mode and enter timebatteries, type R06, UM3 or AA size (not supplied) into the
setting mode.battery compartment: this will act as a power backup to retain
Note:the clock and alarm times only. (Operation of the backlight
If power breakdown backup batteries are inserted, the displayillumination, alarm and radio are excluded).
will also show the PHILIPS demo mode.1. Open the battery door to insert batteries as indicated by
3. To disconnect the set completely from the mains supply,the + and � symbols inside the battery compartment. Close
withdraw the mains plug from the wall socket.the battery door.
2. Connect the mains plug to the wall socket.
Y Replace the batteries once a year, or as often as necessary.
Y Old and new or different types of batteries should not be
used in combination.
Batteries contain chemical substances, so they should
be disposed of properly.
5 |
ACEC
