XP AZ 1018/00-1 13-12-2000 11:55 Pagina 15
Troubleshooting
If a fault occurs,Å¢rst check the points listed below before taking the set for repair.
Do not open the set as there is a risk of electric shock.
If you are unable to remedy a problem by following these hints,consult your dealer or
Englishservice centre.
WARNING:Under no circumstances should you try to repair the set yourself,as this
will invalidate the guarantee.
ProblemSolution
No sound � Adjust the VOLUME
No power� Mains lead not securely connected.
Connect AC mains lead properly
� Batteries exhausted /incorrectly inserted.
Insert (fresh) batteries correctly
Display does not function � Electrostatic discharge
properly/ No reaction to Switch off and unplug the set.
operation of any of the Reconnect after a few seconds.
controls
no d1SC, Cd Err or � No CD inserted, insert a CD
nF d1SC indication� CD badly scratched/ dirty.
Replace/ clean CD (see maintenance)
� CD-R(W) is blank or the disc is not Ţnalized.
Use a Ţnalized CD-R(W)
� Laser lens steamed up.Wait until lens has acclimatized
Laser lens steamed up� Wait until lens has cleared
� Wait until lens has acclimatized
CD playback does not work� CD badly scratched/ dirty.
Replace/ clean CD (see maintenance)
The CD skips tracks� CD damaged or dirty. Replace or clean CD.
� Programme is active. Quit programme mode
Poor cassette sound quality� Dust and dirt on the heads, etc.
Clean deck parts, see maintenance.
� Use of incompatible cassette types (METAL or
CHROME). Only use NORMAL (IEC I) for recording
Recording does not work� Cassette tab(s) may be broken.
Apply a piece of adhesive tape over the missing tab space.
15 |
ACEC
