CD/MP3 PlayerMaintenance / Safety (see 0)Troubleshooting
MP3 only:ALBUM and an album numberIf a fault occurs, first check the points listed below before taking the set for repair.
Safety information
appear, then a stored track number in theIf you are unable to remedy a problem by following these hints, consult your dealer or service centre.
album is displayed.Y Place the set on a flat, hard and stable surface
so that the system does not tilt.WARNING:Do not open the set as there is a risk of electric shock.Under no cir-
Helpful hints:Y Do not expose the set, batteries, CDs tocumstances should you try to repair the set yourself,as this will inval-
idate the guarantee.
� Display shows flashing P01 if no track is pro-humidity, rain, sand or excessive heat caused
grammed.by heating equipment or direct sunlight.Problem no indication
Y The apparatus shall not be exposed to drip-� Possible cause� No disc inserted
Erasing the program ping or splashing.Y RemedyY Insert asuitable disc
You can erase the contents of the memoryY Adequate ventilation with a minimum gap ofNo sound /power� CD badly scratched or dirty
by:15cm (6 inches) between the ventilation� Volume not adjustedY Replace/ clean CD, see Maintenance & Safety
� pressing STOP 9 (twice during playbackholes and surrounding surfaces is necessaryY Adjust the VOLUME� Laser lens steamed up
YWait until lens has cleared
or once in the stop position);to prevent heat build-up.� Power cord not securely connected
� CD-R/CD-RW is blank or not finalized
� selecting TUNER or TAPE sound source;Y Connect the AC power cord properly
Y Do not cover the ventilation openings withY Use a finalized CD-R or CD-RW only
� opening the disc door.items such as newspapers, table-cloths, cur-� Batteries dead/ incorrectly inserted
Y Insert (fresh) batteries correctlyNote:
� Display: PROG disappears.tains, etc.
� Headphones connected to the setMake sure the CD is not encoded with
Y No objects filled with liquids, such as vases,Y Disconnect headphonesCopyright protection technologies,as some
CD player and CD handlingshall be placed on the apparatus.� CD contains non-audio filesdo not conform to the Compact Disc stan-
Y Press , § once or more to skip to a CD
Y If the CD player cannot read CDs correctly,Y No naked flame sources, such as lighted can-audio track, instead of the data file.dard.
dles, should be placed on the apparatus.
use a cleaning CD to clean the lens beforeThe CD skips tracks
taking the set to repair.Y The mechanical parts of the set contain self-Display does not function properly/ No� CD damaged or dirty
lubricating bearings and must not be oiled orreaction to operation of any of the con-
Y The lens of the CD player should never beY Replace or clean CD
touched!lubricated.trols� PROGRAM/ SHUFFLE is active
� Electrostatic discharge
YTo clean the set, use a dry cloth. Do not useY Quit PROGRAM/ SHUFFLE mode
Y Sudden changes in the surrounding tempera-Y Switch off and unplug the set. Reconnect after a
ture can cause condensation on the lens ofany cleaning agents containing alcohol, ammo-few secondsNote:
nia, benzene or abrasives as these may harm
your CD player. Playing a CD is then not pos-For a disc with CD Audio tracks and MP3
the housing.
sible. Do not attempt to clean the lens butSevere radio hum or noisefiles,only the CDAudio tracks will be played.
leave the set in a warm environment until the
� Electrical interference:set too close to TV,VCR or
moisture evaporates.The MP3-CD skips albums
computer� CD contains non-MP3 file folders
YAlways close the CD-tape door to avoid dustY Increase the distance
Y Check your disc contains suitable file folders.
on the lens.
YTo clean the CD, wipe in a straight line fromPoor radio reception
the center towards the edge using a soft, lint-
�Weak radio signal
free cloth. Do not use cleaning agents as they
Y FM:Adjust the FM telescopic aerial.
may damage the disc.
Y Never write on a CD or attach any stickers
to it.
Environmental information
We have done our best to reduce the packaging and make it easy to separate into 3
materials:cardboard, expandable polystyrene, polyethylene.
Your set consists of materials which can be recycled if disassembled by a specialized company.
Please observe the local regulations regarding the disposal of packaging, exhausted batteries
and old equipment. |
ACEC
