AZ 1110/12 10/4/01 18:03 Page 12
AZ 1110/01 page 12
TROUBLESHOOTING
EnglishIf a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
WARNING: Under no circumstances should you try to repair the set yourself, as this would invalidate the
guarantee.
PROBLEMPOSSIBLE CAUSEREMEDY
Set does not react to opera-� Electrostatic discharge.Y Switch off the set, disconnect
tion of any control.the mains plug and reconnect
after a few seconds.
Display does not function� Electrostatic discharge.Y Switch off the set, disconnect
properly.the mains plug and reconnect
after a few seconds.
No sound.� VOLUME is not adjusted.Y Adjust the VOLUME.
� Headphones are connected.Y Disconnect headphones.
� Batteries are exhausted.Y Insert fresh batteries.
� Batteries are incorrectlyY Insert the batteries correctly.
inserted.
� Mains lead is not securelyY Connect the mains lead prop-
connected.erly.
Bad sound.� Batteries are exhausted.Y Replace batteries.
Severe radio hum or noise.� Set too close to TV, VCR orY Increase the distance.
computer.
Poor radio reception.� Weak radio signal.Y FM: aim and extend the tele-
scopic aerial for best recep-
tion;
Y MW: rotate the entire set.
Poor cassette sound quality.� Dust and dirt on the heads,Y Clean the heads etc., see
capstan or pressure roller.Maintenance.
� Use of incompatible cassette� Only use NORMAL (IEC I) for
types (METAL or CHROME).recording.
Recording does not work.� Cassette tab(s) may be brokenY Apply a piece of adhesive tape
out.over the missing tab space.
CD playback does not work.� CD is badly scratched or dirty.Y Replace or clean the CD, see
Maintenance.
� No CD inserted.Y Insert CD.
� CD inserted upside down.Y Insert CD with printed side
facing up.
� Laser lens is steamed up.Y Wait until lens has acclima-
tized.
� MODE pressed but no tracksY Select tracks or erase program.
selected during programming.
The CD skips tracks.� CD is damaged or dirty.Y Replace or clean the CD.
� PROGRAM/SHUFFLE is active.Y Switch off the PROGRAM/-
SHUFFLE function.
12 |
ACEC
