Cassette Recorder Maintenance
Maintenance
Recording from the Radio
Precautions & GeneralCD player and CD handling
1 Adjust the source selector to LW, MW orMaintenance (See 7)(See 7)
FM as desired.
2 Tune to a desired radio station (See RadioY Place the set on a hard and flat surface soY If the CD player cannot read CDs correctly,
that the system does not tilt.use a cleaning CD to clean the lens before
reception)YDo not expose the set, batteries, CDs totaking the set to repair.
3 Follows steps 3-4, under Recording fromhumidity, rain, sand or excessive heat caused
the CD.Y The lens of the CD player should never be
by heating equipment or direct sunlight.touched!
YDo not cover the set.Adequate ventilationY Sudden changes in the surrounding
with a minimum gap of 6 inches between thetemperature can cause condensation on the
ventilation holes and surrounding surfaces islens of your CD player. Playing a CD is then
necessary to prevent heat build-up.not possible. Do not attempt to clean the
Y The mechanical parts of the set contain lens but leave the set in a warm environment
self-lubricating bearings and must not be oileduntil the moisture evaporates.
or lubricated.YAlways close the CD-tape door to avoid dust
on the lens.
YTo clean the set, use a dry cloth. Do not use
any cleaning agents containing alcohol,YTo clean the CD, wipe in a straight line from
ammonia, benzene or abrasives as these maythe center towards the edge using a soft,
harm the housing.lint-free cloth. Do not use cleaning agents as
they may damage the disc.
Tape deck maintenanceYNever write on a CD or attach any stickers
(See 7)to it.
To ensure quality recording and playback of
the tape deck, clean parts A, B and C as
shown, once a month. Use a cotton bud
slightly moistened with alcohol or a special
head cleaning fluid to clean the deck.
1 Open the cassette holder by pressing 9/.
2 Press 2 and clean the roller C.
3 Press ; and clean the heads A, and the
capstan B.
4 After cleaning, press 9/.
� Cleaning of the heads can also be done by
playing a cleaning cassette through once.Environmental information
All unnecessary packaging material has been omitted.The packaging can be easily separated
into three materials: cardboard, polystyrene and plastic.
Your set consists of materials which can be recycled if disassembled by a
specialized company. Please observe the local regulations regarding the
disposal of packaging, dead batteries and old equipment. |
ACEC
