1Eur2030 30-01-2001 17:33 Pagina 7
AZ 2030-35 /00 page 7
DIGITAL TUNER
GENERAL INFORMATION
General maintenance
English
Y Do not expose the set, batteries, CDs or cassettes to humidity,
rain, sand or excessive heat caused by heating equipment or
direct sunlight.
Y To clean the set, use a soft, slightly dampened chamois leather.
Do not use any cleaning agents containing alcohol, ammonia,
benzene or abrasives as these may harm the housing.
Safety information
Y Place the set on a hard and flat surface so that the system does
not tilt. Make sure there is adequate ventilation to prevent the
system from overheating.
Y The mechanical parts of the set contain self-lubricating bearings
and must not be oiled or lubricated.
TUNING TO RADIO STATIONS
1. Select TUNER source.
"is displayed briefly and then the radio station
frequency, waveband and, if programmed, a preset number is
shown.
2. Press BAND once or more to select your waveband.
3. Press SEARCH or § (for AZ2035 model only: or on theBASS REFLEX SPEAKER SYSTEMDIGITAL TUNER
remote control TUNING or §) and release when the
frequency in the display starts running.
" The tuner automatically tunes to a station of sufficient
reception. Display shows during automatic tuning.
" If a FM station is received in stereo, STEREO is shown.
4. Repeat step 3 if necessary until you find the desired station.
Y To tune to a weak station, press SEARCH or § briefly and
repeatedly until you have found optimal reception.
AM
BALOWTT
To improve radio reception
� For FM, pull out the telescopic aerial. Incline and turn the aerial.
Reduce its length if the signal is too strong (very close to a
transmitter).
� For MW (AM/LW), the set is provided with a built-in aerial so
the telescopic aerial is not needed. Direct the aerial by turning
the whole set.
AZ 2030-2035/17
7 |
ACEC
