50 SmartLock (contOd)
To change the access code, follow these steps.
2,4
1
POWEREJECT
Press the COMBI button, then press the MENU button.
SLEEP/WAKE UPSPEEDMEMORY
>SMARTLOCKPRESS BREC/OTRPAUSE/STILL
REVIEW
EXIT
PRIM. SETUPPLAY
VCR PROGRAM
VCR SETUPREWF.FWD
STOP
MENUSTATUS/EXITCLEAR
1
26
123
Press the PLAY/s button or the STOP/t button to select
CH.
SMARTLOCK. Then, press the F.FWD/B button.456
SMARTLOCK
789
_ _ _ _
FM0SURF
VOL.
CABLE/DBSCOMBI
Enter Your Access Code
VCR PLUS+
VAR.SLOW/ENTERMUTE
TRACKINGF.ADVSLOW
SMART
3PICTURESOUNDSEARCHSKIP SEARCHINDEX
Use the Number buttons to enter your old access code.
The default code is 0711. If you have never set up your personal
access code, use 0711 now.
After you enter the code, the SMARTLOCK menu will appear.
SMARTLOCK
X X X -
3,5
Enter Your Access Code
Helpful Hints
Y In order to protect the privacy of
4
the access code, an X will appear
Press the PLAY/s button or the STOP/t button to select
on the screen instead of the num-
CHANGE CODE. Then, press the F.FWD/B button.
ber you enter.
SMARTLOCK
Y If a OWrong Code...� message
BLOCK
appears on the screen after you
>CHANGE CODEcomplete step 5, you entered the
wrong numbers in the Confirm Code
SELECT KL CHOOSE B
TO END PRESS EXITspace. Repeat the steps on this
page.
Y You cannot use the default code
5
after you set up your personal
Use the Number buttons to enter your desired accessaccess code.
code in the New Code space. Then, enter the same codeY If a power failure occurs, the
in the Confirm Code space.default code, 0711, will be the
Your new access code should be recorded. You will return to theactive access code again.
SMARTLOCK menu.Y If you connect the power cord to an
AC outlet that is controlled by a wall
New Code_ _ _ _
switch, your personal access code
Confirm Code_ _ _ _will be erased every time you turn
off the power at the wall switch.
The default code will be the active
code again.
6
Press the STATUS/EXIT button. |
ACEC
