DSX5500_5540 11/13/02 12:21 PM Page 28
Main Menu (contOd)
Preferences: Banner Duration
Banner durations define how long the banner remains on the
screen after you press INFO. Options are 5, 10, 15, or 20 Preferences: Banner Duration
seconds. The default value is 10 seconds.
Arrow up/down to scroll.
To select the banner duration:Press OK to select.
BACK to previous menu.
1. Press MENU.
2. Press to select OPreferences� and press OK. Preferred Language
5 Seconds
3. Press to select OBanner Duration� and press OK. Screen Format10 seconds
Banner Duration
4. Use the buttons to choose from the options.15 Seconds
Set Favorite Channels
20 seconds
5. Once you have made your selection, press OK.A/V Matrix
Remote Control ID
Preferences: Set Favorite Channels
Refer to Enhanced User Features section, page 21.
Preferences: A/V MatrixOBanner Duration� menu options
If you connected the A/V matrix as described in the
Connections portion of the user manual (refer to page 12), then
you must enable the A/V Matrix in the DIRECTV¨ ReceiverPreferences: A/V Matrix
before you can use it.Arrow up/down to scroll.
Press OK to select.
To enable/disable the A/V Matrix:BACK to previous menu.
1. Press MENU.
Preferred Language
2. Press to select OPreferences� and press OK.Enable
Screen Format
Disable
3. Press to select OA/V Matrix� and press OK.Banner Duration
4. Select OEnable� and press OK.Set Favorite Channels
Once enabled and connected, pressing the SOURCE button onA/V Matrix
Remote Control ID
the remote will switch between the video source(s) connected
to Video IN1 and Video IN2 and satellite programming.
Note: If a video source is not connected or turned on and the
A/V Matrix is enabled, pressing the SOURCE button will still
point to that video input. Your TV will go blank. Hit theOA/V Matrix� menu
SOURCE button to cycle to the next video input or to satellite
programming.
Preferences: Remote Control ID
If you purchase two DSX 5500 or DSX 5540 receivers and use
them in close proximity of each other, control them independ-Preferences: Remote Control ID
ently by assigning a separate ID number to each remote.Arrow up/down to scroll.
Press OK to select.
To change the ID number of the remote control:BACK to previous menu.
1. Press MENU.
2. Press to select OPreferences� and press OK.Preferred LanguageIndependently control 2 receivers
Screen Formatin range of each other by setting
3. Press to select ORemote Control ID� and press OK. a separate ID to each remote.
Banner Duration
4. The only option available is the alternate ID. Select and press OK.Set Favorite ChannelsSet Remote Control ID to 1
5. Press and hold down the SAT and MUTE buttons on theA/V Matrix
remote until the SAT light stays on.Remote Control ID
6. To set the ID number to 1, enter O111� or to set the ID to 0,
enter O000�. The SAT button will blink twice to confirm the
entry.
7. Point the remote at the Receiver and press OK to completeORemote Control ID� menu
the process.
Note: It is important at the end of the procedure to point the
remote at the corresponding DIRECTV Receiver and press OK.
Otherwise, the remote control will change its ID but the Receiver
will not and communication will be lost between the two.
28 |
ACEC
