E9480UD_EN.qx3 05.1.8 4:15 PM Page 10
10 Hookups (contOd)
Connecting to a TV Only
TV has only an Antenna In jack
*This enables use of both VCR and DVD modes.
Connect your Antenna or Cable TV signal to the ANTENNA IN jack
1on the rear of the Recorder. Your antenna or Cable TV signal may have
been connected to your TV. If so, disconnect it from the TV and connect it to
the RecorderOs ANTENNA IN jack.
Connect the supplied RF coaxial cable to the ANTENNA OUT jack
on the rear of the Recorder. Connect the other end of the same RF
2coaxial cable to the Antenna In jack on your TV. Your TVOs Antenna In
jack may be labelled RF In,Antenna In, or 75 ohm. Check your TVOs manual for
details.
Connect the power cords of the Recorder and the TV to a power
3outlet.
Press STANDBY-ON yy to turn on the Recorder.
4
Turn on the TV power. Set it to channel 3. You should see the DVDHelpful Hint
background picture or the Initial Setup screen on the TV. The Initial Setup screen
5will appear the first time you turn on the Recorder.Go to page 18 to continue.Y If OIS TV ON? C03�appears on
If channel 3 is already occupied, you may need to use channel 4 as yourthe display panel,you need to
Recorder's output channel instead.To change the output channel to channel 4,turn on your TV and set it to
press STANDBY-ON y to turn off the Recorder. Press DVD on thechannel 3.This is part of the
remote.Then press and hold the Number 4 button on the remote for severalInitial Setup.You cannot see the
seconds until you see "C04" on the display panel. Now the Recorder's outputInitial Setup screens until you
channel is set to channel 4. Set your TV to channel 4.The Initial Setup screenturn on the TV and have it on
should appear. (To go back to using channel 3 at the TV, press and hold thethe correct Video In channel
Number 3 button on the remote instead.)(channel 3 for this connection). |
ACEC
