Getting Started
EnglishStep 1: Inserting batteries intoStep 2: Setting up the TV
the Remote ControlIMPORTANT!
3Make sure you have completed all
the necessary connections. (See
1pages 6-7 OConnecting TV�).
2
1Turn on the TV and set to the correct
video-in channel. You should see the
Philips DVD background screen on the
1Open the battery compartment.TV.
2Insert two batteries type R06 or AA,� Usually these channels are between the
following the indications (+-) insidelowest and highest channels and may be
the compartment.called FRONT, A/V IN, or VIDEO. See your
TV manual for more details.
3Close the cover.
� Or, you may go to channel 1 on your
TV, then press the Channel down button
repeatedly until you see the Video In
Using the Remote Control to
channel.
operate the Player� Or, the TV Remote Control may have a
1Aim the Remote Controlbutton or switch that chooses different
directly at the remoteIRvideo modes.
sensor (iR) on the front� Or, set the TV to channel 3 or 4 if you
panel.are using an RF modulator.
2Do not put any objects2If you are using external equipment, (eg.
audio system or receiver), turn it on and
between the Remote
Control and the DVDselect the appropriate input source for
Player while operating thethe DVD Player output. Refer to the
equipment ownerOs manual for detail.
DVD Player.
To deactivate Progressive manually
The progressive scan display present 60
PREVIEWPREVIEW MUTEMUTEcomplete frames per seconds, rather than
30 frames per second of interlaced
CAUTION!DIMSLEEP SOUNDSURROUNDscanning (ordinary normal TV system).
� Remove batteries if they are
exhausted or if the Remote ControlWith nearly double the number of line,
progressive scan offers higher picture
is not being used for a long time.resolution and eliminates bothersome
� Do not use old and new or
different types of batteries inmotion artifacts those jagged edge on
moving objects.
combination.
� Batteries contain chemical
substances, so they should beTo enjoy the full quality potential offered
by progressive scan feature, a progressive
disposed properly.scan TV is required. To activate
progressive function, refer to �Progressive
- turning on/offO on page 27.
12
01-34 DVP720_AP21228/07/2004, 3:28 PM3139 246 13522 |
ACEC
