TUNER
Tuning to radio stationsa The system will stop searching when all theY Repeat the above procedure to store other preset radio
available radio stations are stored or when thestations.
1 Press TUNER to select TUNER mode.Englishmemory for 40 preset radio stations is used.
a "TUNER" will be displayed.Notes:
A few seconds later, the current frequency isa The system will remain tuned to the last stored� When 40 radio stations are stored and you attempt to
displayed.preset radio station.store another radio station, the display will show
2 Press TUNER (BAND) again to select the desiredY Repeat the above procedure to store other preset radio" PROGRAM FULL�. If you want to change an
waveband : FM or AM.stations for the other waveband. Remember to selectexisting preset number; repeat steps 4 and 5.
3 Press TUNING ? or ? for more than one second,the next available preset number before proceeding. If� You can cancel manual programming by pressing
then release.not, some of the preset radio stations may be erased.STOPYCLEAR ? on the system only.
a The display will show �SEARCHO until a radio station� During programming, if no button is pressed within 20
Notes:
with sufficient signal strength is found.� You can cancel the automatic programming by pressingseconds, the system will exit program mode
Y Repeat this procedure until the desired station isPROGRAM or STOPYCLEAR ? on the system only.automatically.
reached.
Y To tune to a weak station, briefly press TUNING ? or� If you want to reserve a section of preset numbers, for
example preset numbers 1 to 9, select preset 10 beforeTuning to Preset Radio Stations
? until the display shows the desired frequency and/orstarting automatic programming: now only the presetY Press PRESET 4 or 3 to select the desired preset
when the best reception has been obtained.numbers 10 to 40 will be programmed.number.
a The preset number, frequency and waveband appear
Manual programming
Storing Preset Stations1 Press TUNER.on the display
You can store up to 40 radio stations in the memory. When2 Press TUNER (BAND) to select the desired waveband :
a preset radio station is selected, the preset number
appears next to the frequency on the display.FM or AM.
3 Press PROGRAM for less than one second.
Automatic programminga PROGRAM flag, the frequency and preset number
1 Press TUNER.start flashing.
2 Press TUNER (BAND) again to select the desireda The next available preset number will be displayed
waveband : FM or AM.for selection.
3 Press PROGRAM for more than one second.4 Press TUNING ? or ? to tune to the desired
a PROGRAM flag starts flashing and �AUTOO will befrequency.
displayed.Y If you wish to store the radio station to another preset
a Every available station for the selected wavebandnumber, press PRESET 4 or 3 to select the desired
will be stored automatically. The frequency andpreset number.
preset number will be displayed briefly.5 Press PROGRAM again.
a PROGRAM flag will stop flashing, and the radio
station will be stored.
19 |
ACEC
