CD-XP160W
ENGLISH
Setting the FM/AM span selector Demonstration mode
The first time the unit is plugged in, the
unit will enter the demonstration mode.
You will see words scroll.
To cancel the demonstration mode:
When the unit is in the power stand-by mode (demonstration mode),
press the EQUALIZER/X-BASS/DEMO button. The demonstration
mode will be cancelled and thwe ildil displasay pp.ear
To return to the demonstration mode:
When the unit is in the power stand-by mode, press the EQUAL-
IZER/X-BASS/DEMO button again.
Note:
When the power is on, the EQUA/X-BASS/LIZER DEMO button can
be used to select the pre-programmed equaliser and extra bass
modes.
The International Telecommunication Union (ITU) has established
that member countries should maintain either a 100 kHz or a 50 kHz
interval between broadcasting frequencies of FM stations and 10
kHz or 9 kHz for AM station. The illustration shows the 50/9 kHz
zones (regions 1 and 3), and the 100/10 kHz zone (region 2).
Before using the unit, SPsAeNt tShEeL ECTOR switch (on the rear
panel) to the interval (span) of your area.- System connections -
Preparation for Use
To change the tuning zone:
To turn the power on
1 Press the ON/STAND-BY button to enter the stand-by mode.
2 Set the SPAN SELECTOR switch (on the rear panel) asP rfeoslls towhse. ON/STAND-BY button to turn the power on.4
For 100 kHz FM interval (10 kHz in AM) 100/10
For 50 kHz FM interval (9 kHz in AM) 50/9
3 Whilst pressing down the TUNER (BAND) button and the DISCAfter use:
SKIP button, press the ON/STAND-BY button until "CLPEARres"s t ap-he ON/STAND-BY button to enter the power stand-by
pears.mode.
Caution:
This operation will erase all data stored in memory including clock,
timer settings, tuner preset, and CD programme.
E-10
02/5/27CD-XP160W(X)E1.fm |
ACEC
