INSTALLATION INSTRUCTIONS
5. Pull on handle to slide air conditioner out of cabinet. Place air
conditioner on cardboard.
Unpacking
WARNING
Excessive Weight Hazard
Use two or more people to move and install
air conditioner.
Failure to do so can result in back or other injury.1
Remove packaging materials
1. Handle
Remove and properly dispose of packaging materials.
Remove tape and glue residue from surfaces before turning
NOTE: Do not lift, push, pull or remove any expanded
on the air conditioner. Rub a small amount of liquid dish soap
polystyrene (foam) from inside the air conditioner. It is not
over the adhesive with your fingers. Wipe with warm water
packing material.
and dry.
Do not use sharp instruments, rubbing alcohol, flammable Shipping bracket removal (on some models)
fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your air conditioner. 1. To remove upper shipping bracket from unit support bracket,
cut the 2 wire ties with scissors.
Handle air conditioner with care.
2. Lift the end of the upper shipping bracket off of the unit
1. Remove air conditioner from carton and place on cardboard.
support bracket and remove the other end from compressor
2. Remove shipping screws from each side wall of cabinet.flange.
1
2
1
1
1. Shipping screws3
3. Remove front panel from air conditioner and set aside.
4. Remove ground screw and ground wire from front of air
conditioner base. Save ground screw.
5
14
6
1. Wire ties (2)4. Compressor flange
2. Unit support bracket5. Remove this screw
3. Upper shipping bracket6. Lower shipping bracket
23. Remove screw from end of lower shipping bracket attached
1. Green ground wireto divider wall using a 1D? in. nut driver or socket wrench.
2. Ground screw
4. Remove the other end of lower shipping bracket from
compressor flange.
NOTES:
If compressor flange interferes with sliding air conditioner
back into cabinet, bend flange back against the compressor.
Reinstall shipping brackets only if unit will be moved from its
present location.
6 |