Care & Cleaning
To set Self-Clean:
Self-Clean Oven
CAUTIONNote: Oven temperature must be below 400° F to program
a clean cycle.
Y It is normal for parts of the range to become hot during a
self-clean cycle.1. Close the oven door.
Y To prevent damage to oven door, do not attempt to open2. Press the Clean pad.
the door when LOCK is displayed.
Y CLEAN flashes in the display.
Y Avoid touching cooktop, door, window or oven vent areaY SET flashes in the display.
during a Clean cycle.
3. Press the Autoset 0 pad.
Y Do not use commercial oven cleaners on the oven finish
or around any part of the oven. They will damage theY OMEd� (Medium Soil, 3 hours) is displayed.
finish or parts.4. Press the Autoset 0 pad to scroll through the self-cleaning
settings.
The self-clean cycle uses above-normal cooking temperaturesOHVy� (Heavy Soil, 4 hours)
to automatically clean the oven interior.
The oven should be cleaned regularly by wiping up spilloversOMEd� (Medium soil, 3 hours)
to prevent excessive smoke and flare-ups. Do not allow aOLITE� (Light Soil, 2 hours)
heavy build-up of soil to accumulate in the oven.Choosing the soil level of the oven automatically programs
During the cleaning process, the kitchen should be wellthe self-cleaning time.
ventilated to get rid of normal odors associated with cleaning.
5. After four seconds, the oven will start cleaning.
Y If the door is not closed, beeps will sound and Odoor� will
Before Self-Cleaningdisplay. If the door is not closed within 30 seconds, the
1. Turn off the oven light before cleaning. The light may burnself-cleaning operation will be canceled and the display
out during the clean cycle.will return to the time of day.
2. Remove all pans and oven racks from the oven. The ovenY CLEAN will appear in the display.
racks will discolor and may not slide easily after a self-Y LOCK will flash in the display. Once the door locks, the
clean cycle if they are not removed.word will remain steady.
3. Clean oven frame, door frame, areaY The cleaning time will start counting down in the display.
outside of gasket, and around the
opening in the door gasket with aTo Delay a Self-Clean Cycle:
nonabrasive cleaner such as Bon1. Press the Delay 1 pad.
Ami* or detergent and water. The
self-cleaning process does notY DELAY flashes.
clean these areas. They should beY 00:00 will flash in the display.
cleaned to prevent soil from baking on during the clean2. Enter the amount of time you want to delay the cycle using
cycle. (The gasket is the seal around the oven door andthe appropriate number pads.
window.)
3. Press the Clean pad.
4. To prevent damage, do not clean or rub the gasket aroundY SET flashes in the display.
the oven door. The gasket is designed to seal in heat
during the clean cycle.4. Press the Autoset 0 pad.
5. Wipe up excess grease or spillovers from the oven bottom.Y OLITE� (Light soil level) is displayed.
This prevents excessive smoking, flare-ups or flamingcont.
during the clean cycle.
6. Wipe up sugary and acidic spillovers such as sweet
potatoes, tomato, or milk-based sauces. Porcelain enamel
is acid-resistant, not acid-proof. The porcelain finish may
discolor if acidic spills are not wiped up before a self-clean
cycle.
* Brand names for cleaning products are registered trademarks of the respective manufacturers.
18 |
ACEC
