TROUBLE-SHOOTING GUIDE
The appliance will not switch on or stMacops in hine vibrates during spin cycle.
the middle of the programme. Machine perfectly horizontal with all four feet
Power plug properly inserted in mains on ground? (See ?Installation Inst?ru).ctions
socket? Transit bolts removed? The transit bolts must
Mains fuse OK?be removed before the machine is used (see
Power failure??Installation Inst?ru).ctions
Tap turned on? Is water coming through?Final spin results are poor.
Door closed? Pump impeller obstructed? (See ?Removing
Programme selected?the Filter / Draining Resi?dual Water).
?On/Off? button pressed? Wash consists of a single heavy/large size
No water or insufficient water supply.article (bathrobe, etc.)? If this is the case the
wash machine may detect load imbalance at
Tap turned on completely?the start of the spin cycle and interrupt the
Kink in water hose?spin. The machine breaks up the load and
Water hose filter clogged??Care and (See starts a new spin cycle.
Maintenance?). If this happens several times in a row, the
Water hose frozen up?spin is run at reduced speed or if the
imbalance is too great is not run at all.
Waste water not pumped out. If the load is too wet at the end of the
Drain hose installed correctly? (See programme, add further garments and run a
?installation Instruc?). tionsnew spin cycle.
Filter clogged? (See?Remov ing the Filter / Important This: machine is fitted with a safety
Draining Residual Water?).system. The programme is interrupted after a
Drain hose frozen up?few minutes if one of the following happens:
Is the rinse hold button pressed? No water supply.
Pump blocked.
Detergent and additive product residues in
To restart the machine, switch it off and on
detergent drawer at end of wash.
Siphon installed correctly?again.
Siphon clogged?
Not enough water delivered? (See above).
Also see ?Detergent and Addi?tive and s
?Care and Maintenance?.
AFTER-SALES SERVICE
Before contacting After-Sales Service:
1. Try to remedy the problem (see ?Trouble-
Shooting Guid?).e
2. Restart the programme to see if the fault is
repeated.
3. If the malfunction persists, call AfteThe After-Sales Service sr- Sales ticker is on the
Service and specify:inside of the door.
The nature of the problem.
The exact model of the appliance.
The service code (number after the word
SERVICE).
Your full address.
Your telephone number and area code.
The After-Sales Service telephone number
and address can be found in the warranty or
on application to the retailer.
83 |
ACEC
