3gb15103.fm Page 5 Friday, August 27, 2004 6:52 PM
BEFORE USING THE WASHING MACHINE
1.Remove the packaging and check5.Drain hose
? After unpacking, make sure that the washing Connect the drain hose to the ventilated siphon
machine is undamaged. If in doubt, do not use the or hook it over the edge of a sink by means of the
washing machine. Contact After-Sales Service or ?U? bend (see ?Installation/Connect the water
your local dealer.drain hose?).
Keep the packaging materials (plastic bags,
polystyrene parts, etc.) out of reach of children, 6.Electrical connections
since it is a possible source of danger. Electrical connections must be carried out by a
qualified electrician in compliance with the
2.Remove the transit boltsmanufacturer's instructions and local safety
The appliance is fitted with transit bolts to regulations.
prevent internal damage during transport. Voltage information, power consumption and
Before using the washing machine you must electrical fusing data are supplied on the front
remove the transit bolts (see ?Installation/panel behind the door frame.
Remove the transit bolts?). The appliance must be connected to the mains
exclusively by means of a socket with an earth
3.Install the washing machineconnection in accordance with established
Install the appliance on a solid and level floor regulations. The appliance must be earthed by
surface. In the case of a yielding sub-floor, the law. The manufacturer declines all liability for
appliance should be installed in the corner of a possible damage to property or injury to persons
room.or pets deriving from failure to observe the a/m
Adjust the feet to ensure that the machine is directions.
stable and level on the floor (see ?Installation/ Do not use extension leads or multi sockets.
Adjust the feet?). Before any maintenance on the washing machine
disconnect the power plug or switch off the
4.Water inletpower supply.
Connect the water supply inlet hose in Access to the mains plug or to disconnection
accordance with the regulations of your local from mains supply via a double-pole switch must
water company (see "Installation/Connect the be ensured at all times following the installation.
water inlet hose").
Do not operate the washing machine if it has
? Water supply: Cold water only been damaged during transport. Inform the
Tap:3/4? threaded hose connectionAfter-Sales Service.
Pressure: 100-1000 kPa (1-10 bar). Mains cable replacement is only to be carried out
by After-Sales Service.
The washing machine must only be used in the
household for the prescribed uses.
5
Black process 45.0° 150.0 LPI |
ACEC
