MAINTENANCE AND CLEANING
Before carrying out any maintenance or cleaning isolate the cooker hood from the mains supply.
Charcoal Filters
In the recirculation mode the charcoal Ţ lters absorb smells and unwanted odours.
Enabling the alarm signal
? In Recirculation version Hoods, the Filter saturation alarm can be enabled on installation or at a later date.
? Turn the Lights and the suction Motor off.
? Disconnect the Hood using the Main switch or the double-pole switch on the mains power supply.
? Restore the connection by pressing and holding T1.
? Release the button. All Ţ ve LEDs are turned on
? Within 3 seconds press T1 until LEDs T1 and T4 � ash in conŢ rmation:
? LED � ashes twice - Activated charcoal Ţ lter saturation alarm ENABLED
? LED � ashes once - Activated charcoal Ţ lter saturation alarm DISABLED
The Ţ lter is not washable and cannot be regenerated. It must be replaced when led S1 � ashes or at least every
4 months. The alarm signal will only light up when the extractor motor is switched on.
To Remove/Replace the Charcoal Filters
? Remove the metal grease Ţ lters
? Remove the saturated activated carbon Ţ lter by
releasing the Ţ xing hooks
? Fit the new Ţ lter by hooking it into its seating
? Replace the metal grease Ţ lters.
This appliance can be a possible Ţ re
hazard if the grease and charcoal Ţ lters
are not cleaned and replaced as recommended.
Alarm signal reset
? Switch off the lights and extractor motor.
? Press button T3 for at least 3 seconds, until the
leds start to � ash.
Changing the halogen light
? Remove the snap-on lamp cover by levering it from
under the metal ring, supporting it with one hand.
? Remove the halogen lamp from the lamp holder by
pulling gently.
? Replace the lamp with a new one of the same type,
making sure that you insert the two pins properly into
the housings on the lamp holder.
? Replace the snap-on lamp cover.
8 |
ACEC
ELECTROLUX
