Removing the oven door (Fig. 15 & 16)
Warning:
It is important that the retaining discs are
fully turned and located as the hinges are
under high sprung tension.
1. Open the door completely so that it is in the
+
horizontal position.
2. Raise the two bars.
3. Raise the door halfway.
4. At this stage, claps the two hinges on either
side of the door together simultaneously.
FO 0417
The door can then be removed by pullingFig. 15
on and downwards., maintaining the angle.
Replacing the oven door
1. Clasp the two hinges on either side of the
+door simultaneously.
2. Hook the top hinge into the top slot, so that
the hook is engaged with the roller.
3. Drop the lower hinge into the lower slot, so
that the notch is engaged. Drop the door
down so it is in the horizontal position.
Note
Is it important when carrying out this
operation, that both hinges be located
simultaneously.FO 0967
Fig. 16
4. Turn the bars.
The door can then be closed.
Replacing the Oven Light
If the oven bulb needs replacing, it must comply with
the following specifications:
- Electric power: 15W,
- Electric rate: 230 V (50 Hz),
- Resistant to temperatures of 300°C,
- Connection type: E14.
These bulbs are available from your local Force
Service Centre.
To replace the faulty bulb:
+1. Ensure the oven is isolated from the electrical
supply.
2. Turn the glass cover anticlockwise (Fig. 17)FO 0424
Fig. 17
3. Remove the faulty bulb and replace with the
new one.
4. Refit the glass cover.
5. Restore the electrical supply.
20 |
ACEC
ELECTROLUX
