EMS1740 t English
GETTING STARTED
UnpackingConnecting to the mains
N.B. When you unpack the oven, check that tThe oven is delheivered with the power cord and a plug
product is free from damage. Damage or any missinfor 230V,g 50Hz, earthed socket outlet. Earth
parts must be reported immediately to the retprotaectiler.ion minimises the risks should a short-circuit
The oven, parts of the oven or the accessorioccur.es may Check to ensure the voltage of the oven
be wrapped by a protection foil. If so, you mustmatches the supply.
remove this foil before using the oven. Do not leave
packing material so that small children can pN.B.l Iay witf the oven is connecthed to the socket via an
it. This can be hazardous.extension cord, make sure the cord is earthed.
WARNING! This appliance must not be used on a
Installationnon-earth protected power supply.
Contact an electrician if you are uncertain regarding
1. Remove any promotion label from the door.
2. Install the oven on a flat, level surfelectace. Tricahel connection of the oven or provision of earth
surface must be strong enough to safely beprotar tecthieon of the supply.
weight (15.5 kg) of the oven, and the contents. To
This appliance must be earthed. If this appliance is
avoid the possibility of causing vibration or noise
the oven must be in a stable position.fitted with a non-rewireable plug for which your socket
is unsuitable, the plug should be cut off and the
3. Keep the oven away from heat and water.
appropriate plug fitted. If it is necessary to change the
Exposure to heat and water can lower oven
efficiency and lead to malfunctioning, so be surefuse in a non-rewireable plug, the fuse cover must be
to install the oven away from heat and wrefatiertted. If the fuse cover is lost or damaged, the plug
must not be used until a replacement is obtained.
sources.
4. Do not block air vents on the top and the sides of
the cabinet and also do not place any articles on
the top of the oven. If air vents are blocked durinElectricalg connections
operation, the oven may overheat, and this may
lead to malfunctioning. Hot air escapes fWARNIrom tNGh! TeHIS APPLIANCE MUST BE
vents, so be sure not to obstruct it or letEART curtHED. ains
come between the oven and the rear wall.
5. Place the oven as far away from radios anThd Te manV?sufacturer declines any liability should
as possible. This oven does conform to EECthis safety measure not be observed.
requirements* of radio interference suppression,
but some interference may occur if it is placed t? If the plug toohat is fitted to your appliance is not
close to a radio or TV, so keep them as far apartsuitable for your socket outlet, it must be cut off
as possible.
and the appropriate plug fitted.
6. If positioned in a corner, leave a gap of at least
5,0 cm from the walls to meet ventilation
? Remove the fuse from the cut off plug. The cut off
demands.
plug should then be disposed of to prevent the
hazard of shocks in case it should be plugged into
Important! The oven can be placed almost anywhere
a 13 Amp socket in another part of your home.
in the kitchen. Make sure the oven is placed on a flat,
level surface and that vents as well as the surface
underneath the oven are not blocked (for sufficient
ventilation).
* This appliance conforms to the requirements of
EEC Radio Interference Directive 87/308/EEC.
8 |
ACEC
ELECTROLUX
