INSTALLATION
If this appliance featuring magnetic door seals isInstructions for totally built-in appliances
to replace an older appliance having a spring lock
Dimensions of the recess
(latch) on the door or lid, be sure to make that
spring lock unusable before you discard the oldHeight1225 mm
appliance.Depth550 mm
Width560 mm
This will prevent it from becoming a death-trap for
a child.
The applianceOs door has been locked in position
for transport by means of pins on both sides. Ac-
Positioning
cording to the door opening direction, remove rel-
The appliance should be installed well away fromevant pins at the top and at the bottom.
sources of heat such as radiators, boilers, direct sun-
light etc.For appropriate venting, follow indications in Fig. 1.
Best performance is obtained with ambient tempera-
2Fig. 1
ture between +18°C and +43°C (class T); +18°C and50-min. cm 200
+38°C (class ST); +16°C and +32°C (class N); +10°C
and +32°C (class SN).
The class of your appliance is shown on its rating
plate.
For building into kitchen units follow the special
OBuilding-in� instructions given.
min.
Electrical connection2
cm 200
Before plugging in, ensure that the voltage and fre-
quency shown on the serial number plate correspond
D028
to your domestic power supply.
Fig. 2
Voltage can vary by ?6% of the rated voltage.
For operation with different voltages, a suitably sizedAPush appliance
auto-transformer must be used.into the housing
until stop strip (A)
The appliance must be earthed.
touches the kitch-
The power supply cable plug is provided with a con-
en unit.
tact for this purpose.
If the domestic power supply socket is not earthed,
connect the appliance to a separate earth in compli-
ance with current regulations, consulting a specialist
technician.
The Manufacturer declines all responsibility if the
D022
above safety precautions are not observed.
This appliance complies with EEC directiveFig. 3
number 87/308 of 2/6/87 relative to radio inter-If after having car-
ference suppression.ried out the previ-
This appliance complies with the followingAously described
E.E.C. Directives:operation there is
- 73/23 EEC of 19.2.73 (Low Voltage Directive) andstill some space
subsequent modiŢcations;left between the
- 89/336 EEC of 3.5.89 (Electromagnetic Compatibil-appliance and the
ity Directive) and subsequent modiŢcations.kitchen unit, Ţt the
trimming provided
together with the
Cleaning the interior
D265appliance on the
Before using the appliance for the Ţrst time, wash the
stop strip (A).
interior and all internal accessories with lukewarm wa-
ter and some neutral soap so as to remove the typical
smell of a brand-new product, then dry thoroughly.
Do not use detergents or abrasive powders, as these
will damage the Ţnish.
10 |
ACEC
ELECTROLUX
