Electrical connection
USE
Before plugging in, ensure that the voltage and
frequency shown on the serial number plateCleaning the interiorFresh food refrigeration
correspond to your domestic power supply. Voltage
To obtain the best performance:
can vary by ?6% of the rated voltage.Before using the appliance for the first time, wash
the interior and all internal accessories with luke-
Y do not store warm food or evaporating liquids in
For operation with different voltages, a suitably sized
warm water and some neutral soap so as to remove
the refrigerator;
auto-transformer must be used.
the typical smell of a brand-new product, then dry
Y do cover or wrap the food, particularly if it has a
The appliance must be earthed.thoroughly.
strong flavour.
The power supply cable plug is provided with aDo not use detergents or abrasive
Y Position food so that air can circulate freely round
contact for this purpose.powders, as these will damage the finish.
it.
If the domestic power supply socket is not earthed,
connect the appliance to a separate earth in
compliance with current regulations, consulting aOperation
specialist technician.
Insert the plug into the wall socket.
The Manufacturer declines all responsibility if
Open the refrigerator door and turn the thermostat
the above safety precautions are not observed.
knob, clockwise, beyond the �OE (STOP) position.
This appliance complies with the followingThe appliance will start to operate.
E.E.C. Directives:
To stop operation, simply turn the thermostat knob to
- 87/308 EEC of 2/6/87 relative to radio interference
position �OE
suppression.
- 73/23 EEC of 19.2.73 (Low Voltage Directive) and
Temperature regulation
subsequent modifications;
The temperature is automatically regulated and can
- 89/336 EEC of 3.5.89 (Electromagnetic
be increased to achieve a higher temperature
Compatibility Directive) and subsequent
(warmer) by rotating the thermostat knob toward
modifications.
lower settings or reduced (colder) rotating the knob
towards higher settings.
However, the exact setting should be chosen
keeping in mind that the temperature inside the
refrigerator depends on:
Y room temperature;
Y how often the door is opened;
Y the quantity of food stored;
Y location of appliance.
A medium setting is generally the most suitable.
Rear spacers
Important
In the bag with the documentation, there are two
spacers which must be fitted as shown in theIf the ambient temperature is high or the
figure.appliance is fully loaded, and the appliance is
set to the lowest temperatures, it may run
Slacken the screws and insert the spacer under the
continuously causing frost to form on the rear
screw head, then re-tighten the screws.
wall. In this case the dial must be set to a higher
temperature to allow automatic defrosting and
therefore reduced energy consumption.
PR153
2215 |
ACEC
ELECTROLUX
