Installation instructions
Any electrical work required to install this applianceWater outlet hose connection
should be carried out by a qualified electrician or
competent person.The end of the drain hose can be connected in the following
ways:
Any plumbing work required to install this appliance
1.To the sink outlet spigot, securing it if necessary with a clip.
should be carried out by a qualified plumber or competent
person.2.To a stand pipe provided with vent-hole, minimum internal
diameter 4 cm.
Remove all packaging before positioning the machine.
If possible, position the machine next to a water tap and a
drain.12
Attention!
Carefully follow the instructions on the enclosed template forO 21min 4 cm
building in the dishwasher and fitting the furniture panel.O 18
Water supply connections
This dishwasher may be fed with either hot (max. 60°) or cold
water. Nevertheless we advise you a cold water supply.min 30 cm max 100 cm
CS13
A hot water supply is not always efficient with very soiled
crockery as it shortens the washing programmes a lot.The waste connection must be at a height of between 30 cm
The water pressure must be within the limits given in the(minimum) and 100 cm (maximum) from the bottom of the
technical specifications. dishwasher.
Your local Water Authority will advise you on the averageThe drain hose can face either to the right or left of the
mains pressure in your area. dishwasher
The dishwasher features fill and drain hoses which can beEnsure the hose is not bent or squashed as this could prevent
turned either to the left or the right to suit the installation. or slow down the discharge of waterThe.
locknut must be correctly fitted to avoid water leaks. If you use a drain hose extension it must be no longer than 2
Avoid bends or kinks in the hose which could prevent or slowmetres and its internal diameter must be no smaller than the
down the water supply. diameter of the hose provided.
If the machine is connected to new pipes or pipes which have
not been used for a long time, you should run the water for a
few minutes before connecting the inlet hose. This will prevent
deposits of sand or rust clogging the inlet hose filter.
For making the connection itself, the coupling nut fitted to the
machines supply hose is designed to screw onto either a 3/4
O 18O 21
inch gas thread spout, or to a purpose made quick-coupling
tap such as the Press-block.
Do not use, for connection, old hoses which have been+ 2 m maxmin 30 cm max 100 cm
CS14
used in another appliance.
Be sure to incorporate theLikewise the internal diameter of the couplings used for
connections to the waste outlet must be no smaller than the
filter (A), supplied with the
diameter of the hose provided.
machine, onto the joint.
The sink plug must not be in place when the machine is
draining as this could cause the water to siphon back into the
machine.
Attention!
Our appliances are supplied with a security device to protect
A
against the return of dirty water back into the machine. CA03
If the spigot of your sink has a "no return valve" incorporated
this can prevent the correct draining of your dishwasher.
We advise you therefore to remove it.
14 |
ACEC
ELECTROLUX
