Before use
Before using your dishwasher for theFilling with salt
first time:Attention!
Only use salt specifically designed for use in
1.Ensure that the electrical and water connections comply
dishwashers.
with the installation instructions
All other types of salt not specifically designed for use in
2.Remove all packaging from inside the appliance
dishwasher, especially table salt, will damage the water
3.Set the water softener
softener.
4.Pour 1 litre of water inside the salt container and then fill Only fill with salt just before starting a washing
with saltprogramme. This will prevent any grains of salt or salty
5.Fill the rinse aid dispenser.water, which may have been spilled, remaining on the
6.Run a "Rinse and Hold" programme.bottom of the machine, which may cause corrosion.
To fill:
Setting the water softener
1.To fill with salt, unscrew the cap of the salt container.
The dishwasher is equipped with a water softener designed to
remove minerals and salts from the water supply, which would2.Pour 1 litre of water inside the container (this is necessary
have a detrimental or adverse effect on the operation of theonly before filling with salt for the first time).
appliance.
3.Using the funnel (if
The higher the content of these salts, the harder your water is.
provided), pour in the salt
Water hardness is measured in equivalent scales, Clarke,SALE
until the container is full. SALT
French degrees and PPM (parts per Million).SALZ
Do not worry if water over SEL
The softener should be adjusted according to the hardness of
flows from the unit when
the water in your area. Your local Water Authority can advise
filling with salt, this is quite
you on the hardness of the water in your area.
normal.
The dishwasher is factory set at level 2.
4.Replace the cap making
If this level is not suitable for your area the softener should be
sure that there is no trace
adjusted.
of salt on the screw thread SR06
If your water is level 0 it is already soft and therefore
or on the gasket.
there is no need to use salt.
In this case adjust the water softener on level 1 without5.Screw on the cap tightly.
using salt.
The salt container will require topping up periodically.
Water hardness
According to the model, an indicator reminds you when filling
ClarkeFrenchPPM
with salt:
degrees degrees(Parts perLevelUse of
(!TH)Million)A)The salt cap has a refill salt
0 - 60 - 80 - 800NOindicator window in the centre.
A green float is clearly
7 - 149 - 2081 - 2001YES
visible when there is salt
15 - 2821 - 40 201 - 4002YESinside the container, and
almost disappears when the
29 - 4241 - 60 401 - 6003YES
salt has finished reminding
61 - 8043 - 56601 - 8004YES
you to add salt.
57 - 6381 - 90 801 - 9005YESSR11
B) A salt indicator light on the
control panel will come on
Only for dishwasher models with salt refillwhen the salt has finished.
indicator light:
The salt indicator light on the control panel can remain
if the water softener has been adjusted on level 1 without use
illuminated for 2-6 hours after the salt has been
of salt, the salt refill indicator light on the control panel will
replenished, assuming the dishwasher remains switched
always remain illuminated when the machine is switched on.
on. If you are using salts that take longer to dissolve then
this can take longer.
The function of the machine is not affected..
To adjust the water softener
With a screwdriver turn the selector on the upper front corner
of the machine until the level
required corresponds with the
marker.
34
25
21
2 |
ACEC
ELECTROLUX
