GB
Once defrosting is completed, dry the wet surfacesRemove all foods from the product.
and push back the defrost water drain.Perform defrosting and cleaning operations as
Connect the product to the mains.described above.
Rotate the thermostat to position <<-18C>> and letLeave the doors ajar to avoid the build-up of
the product operate in quick freeze mode for at leastunpleasant odors.
2 hours before putting back the formerly removed
frozen foods.Trouble shooting
Regular cleaningDuring operation of the appliance some smaller but
annoying trouble can often occur, which does not
It is practical to clean the inside of the freezer andrequire calling a technician out. In the following
defrost it at a time.
chart information is given about them to avoid
Household cleaner or soap must not be used.unnecessary charges on service.
After breaking the circuit wash the appliance usingWe draw your attention that operation of appliance
lukewarm water and wipe it.goes with certain sounds (compressor- and
Clean the door gasket with clean water.circulating sound). This is not trouble, but means
normal operation.
After cleaning apply voltage to the appliance.
It is recommended to remove the dust and dirtWe draw it to your attention again that the
collected on the back of the appliance and theappliance operates discontinuously, so the
stopping of compressor does not mean being no-
condenser once or twice a year.current. That is why you must not touch the
Long-term abscenceelectrical parts of the appliance before removing it
from the mains socket.
If you do not use the product for longer periods, make
sure to perform the following:
Set the thermostat to position << >>.
Disconnect the product from the mains.
ProblemPossible causeSolution
Cooling is too weak.Thermostat is set too low. Set to higher position.
No sufficient pre-cooling done before freezing started.Provide for sufficient pre-cooling time.
Too large food inserted:Cut food into pieces.
Too much food inserted for freezing at the sameInsert less food.
time.Insert food of max. room temperature.
Food inserted while still hot.Check if door is fully closed.
Door not fully closed.
Cooling is too strongThermostat is set too high.Set to lower position.
No cooling at all.Plug is not properly inserted into socket.Check plug-socket connection.
No current in socket.Check presence of current.
Thermostat set to "0" position.Check thermostat setting.
Noisy operationProduct support is not correct.Check stability of product support (all four feet
should stand on floor).
If you fail to remedy a problem, please contact the nearest authorized service unit.
Operation failure
When the electronic system fails to detect the ACTUAL temperature, the alarm indicator will start to flash. The
product will continue to operate with the use of a reserve system until the problem is eliminated by the local
service personnel.
51 |
ACEC
ELECTROLUX
