132996780.qxd 9/7/01 8:38 PM Pagina 8 (Nero/Process Black pellicola)
Water drainageElectrical connection
The end of the drain hose can be positioned in threeThis machine is designed to operate on a 220-230 V,
ways:single-phase, 50 Hz supply.
Hooked over the edge of a sink using the plasticCheck that your domestic electrical installation can
hose guide supplied with the machine. In thistake the maximum load required (2.2 kW), also
case, make sure the end cannot come unhookedtaking into account any other appliances in use.
when the machine is emptying.
This could be done by tying it to the tap with a pieceConnect the machine to an earthed socket.
of string or attaching it to the wall.
The manufacturer declines any responsibility
for damage or injury through failure to comply
with the above safety precaution.
Should the appliance power supply cable
need to be replaced, this should be carried
out by our Service Centre.
Important
The power supply cable must be easily
accessible after installing the appliance.
In a sink drain pipe branch. This branch must be
above the trap so that the bend is at least 60 cm
above the ground.
Directly into a drain pipe at a height of not less
than 60 cm and not more than 90 cm.
The end of the drain hose must always be
ventilated, i.e. the inside diameter of the drain pipe
must be larger than the outside diameter of the drain
hose.
The drain hose must not be kinked. Run it along the
floor; only the part near the drainage point must be
raised.
8 |
ACEC
ELECTROLUX
