CHAPTER 2. BASIC OPERATION
4. Feeding operation
For cut sheets, the paper is fed until the
paper rear edge reaches a position 3mm
behind the pinch roller, after printing is
completed.
When roll media is cut, the paper is fed to
the position to be cut.
When roll media is not cut, the paper is
fed to the position where the next printing
will start.
5. PE sensor
Existence of paper is detected by the PE
sensor (PS6) installed on the lower right side
of the platen.
The sensor is a reflective-type photo
interruptor. It detects the existence of paper
and the rear edge of the paper by the exist-
ence of light reflected from the paper.
PE sensor (PS6)
Figure 2-505
2�62 |
ACEC
