OverviewThe Cabinet
The C300 has a Speakon? input, andThe cabinet material is very strong and
the C300i has a 1/4 inch phone jack.is rigid enough to prevent unwanted
vibrations and standing waves in the
Apart from this difference, all details in
this manual apply to both models.cabinet. It has built-in fly points for
hanging, and a socket in the bottom
The C300 is a portable two-wayfor mounting on a tripod stand. The
loudspeaker system, capable ofasymmetrical trapezoidal design of the
extremely high sound pressure levels.
cabinet also makes it easy to use as a
floor wedge for stage monitor
applications.
The Transducers
The C300 has a 12? high-power low-
frequency woofer and a 1.75? mylarInputs
diaphragm high-output compression
The C300 input is a Speakon
driver. The woofer incorporatesconnector, wired as follows:
technology used in large-format
touring systems and has a precision 3-Pin 1+ is Positive (+)
inch voice coil.
Pin 1- is Negative (-)
The high-frequency compression driver
(Pins 2- and 2+ are not used)
is mounted on a multi-cell aperture
loaded on a constant directivity horn,The C300i input is 1/4? TS (tip-sleeve),
providing an ultra-wide, controlledwired as follows:
dispersion pattern and precise
The Tip is Positive (+)
reproduction of the critical upper mid-
range and high-frequencies. The resultThe Sleeve is Negative (-)
is an smooth off-axis response.
Each driver has been specifically
designed for optimum performance in
a lightweight high-strength cabinet.
The Crossover
This unique Low Impedance
Compensated Crossover (LICC) design
places inductors in series with the
woofer whose values are markedly
lower than conventional designs. This
reduces the amount of energy that is
typically wasted as heat and increases
the amount of energy that is
transformed into real acoustic power. It
also incorporates dynamic protection
for the compression driver from non-
linear signals.
3 |
ACEC
