English
AccessoriesBeforestartingHowtousethetelescopictube33 Rinse the inside (dirty side) in lukewarm Cleaningthedustcontainer
andsafetyprecautions11 Insert the hose so that the catches click to 21 Extend or shorten the telescopic tube by tap water. Tap the lter frame to remove The dust container can be thoroughly cleaned
engage (press the catches to release the pushing the release button towards the the water. Repeat the process four times. when emptying.
Accessories (depending on the model)Note: Do not use cleaning agents and avoid
hose).nozzle and simultaneously adjusting the 46 Remove the dust container.
1 Max In telescopic tube/telescopic tube with touching the lter surface.
12 Attach the telescopic tube to the hose length of the telescopic tube. There is a 47 Empty it.
power cableLet the lter dry.
handle and the oor nozzle (certain models catch at both ends of the telescopic tube. 48 Remove the cover on the side of the round
2 Max In hose handlePut the lter back into place, close the lter
have a lock button that must be pressed Certain models only have one release space by pulling it straight out.
3 Max In hose handle with remote controlbefore the hose and telescopic tube can be button.cover and ret the dust container.
4 Max In nozzleThe dust container can now be wiped o or
pulled apart). If you have a vacuum cleaner
5 Max In motorised oor nozzleEmptyingthedustcontainerClearingthehoseandnozzlecleaned. If you use water, make sure that the
with remote control, make sure that the
6 Max In turbo nozzleElectrolux Twinclean?s dust container must be The vacuum cleaner automatically stops if there cartridge is dry before you put it back. Ret the
connector is pressed in completely.
cover back on by pushing it straight in. Put back
7 Nozzle with pedal, telescopic tube and hose13 Electrolux Twinclean features an automatic emptied when it is full to the Max sign. The dust is a blockage in the nozzle, tubes or hose or if the the dust container.
8 Crevice nozzlecontainer must never be overlled.lter or lter holder becomes blocked. Pull out
cord winder (autoreverse). Pull out the
9 Upholstery nozzle22 Press the release button at the rear of the power plug and allow the vacuum cleaner Troubleshooting
power cord and plug into a socket. Pull
10 Dusting brushvacuum cleaner.to cool down for 2030 minutes. Remove the
lightly on the cord to release the catch.
23 Lift the dust container out.blockage that is causing the problem, and/or The vacuum cleaner does not start
Safetyprecautions14 Start/stop the vacuum cleaner by pushing 24 Empty it over a wastepaper basket by replace the dirty lter. Restart the vacuum Check that the cable is connected to the mains.
Electrolux Twinclean should only be used by the button at the top of the unit.cleaner. Check that the plug and cable are not
pressing the release button. Put the dust
adults and only for normal indoor vacuuming 15 If you have a vacuum cleaner with remote 34 Use a suitable implement to clear the tubes damaged.
container back and press the rear part of
in a home environment. The vacuum cleaner control, the vacuum cleaner is started by and hose of blockages. Check for a blown fuse.
the container until it clicks into place.
features double insulation and does not need to lightly pressing the Max or Min button. Turn 35 It is sometimes possible to clear the hose by
be earthed.o the vacuum cleaner by pushing O?.Cleaningthedust|lter?massaging? it. However, be careful in case The vacuum cleaner stops
16 Adjust the suction power by pressing the Electrolux Twinclean has a dust lter that should Check if Twinclean is full. If so, empty it and
Young children should be supervised to ensure the obstruction has been caused by glass
Max-Min button on the vacuum cleaner or be cleaned now and then to secure a constant clean both the box and the lter before putting
that they do not play with the appliance. or needles caught inside the hose. Note:
by pressing either the Max or Min button high suction. When it is time to clean the lter, it back in the cleaner.
Close attention is necessary when used near The warranty does not cover any damage to Is the nozzle, tube or hose blocked?
on the remote control. The light for suction the lter light on the vacuum cleaner will ash.
children. The appliance is not intended for use hoses caused by cleaning them. Are the lters blocked?
power turns dark blue at max suction The lter is cleaned while in the vacuum cleaner.
by young children and inrm persons without
power and light blue at min suction power.25 Turn o the vacuum cleaner when the lter Ifsomethinggetsstuck
supervisison.Water has entered the vacuum cleaner
light ashes.inthevacuumcleaner
GettingthebestresultsIt will be necessary to replace the motor at an
If the plug or cable are damaged, the plug and 26 Open the cover by lifting the release catch.If something gets stuck in the vacuum cleaner:
HardDoorsandcarpets:The Max In, Max In authorised Electrolux service centre. Damage to
cable assembly must be replaced by returning 27 Lift up the lter holder and turn it a half 36 Turn o the vacuum cleaner and open the
Turbo and Max In motorised oor nozzles (5) the motor caused by the penetration of water is
the product the your local Electrolux Service turn so that the lters change places with cover at the front of the unit by lifting the
Agent or similarly qualied person in order to detect the type of surface being vacuumed. The each other and put the lters back into the release catch.not covered by the warranty.
avoid a hazard.nozzle with the pedal is set to the type of surface vacuum cleaner. 37 Lift out the lter holder and the lters.Consumerinformation
to be vacuumed: Position 1 for carpets (17) and Electrolux decline all responsibility for all
28 Turn the left lter a full turn in the direction
Never vacuum:position 2 for hard ?oors (18).38 Lift the cover between the lter wells and damages arising from any improper use of the
of the arrow. The lter light begins to ash
? In wet areas.Crevices,corners,etc.: Use the crevice nozzle remove anything that may have got stuck.
appliance or in cases of tampering with the
? Close to ammable gases, etc.(8).and the vacuum cleaner starts, and as you Also check the bottoms of the lter wells for
appliance.
turn, the lter is cleaned. After you have foreign objects.
Upholsteredfurniture: Use the upholstery
Never vacuum:made a full turn, the vacuum cleaner turns 39 Ret the cover under the catches and close This product is designed with the environment
nozzle (9).
? Sharp objects.o and the lter light stops ashing. You it by pressing down. Put the lter holder
Curtains,lightweightfabrics,etc.: Use the in mind. All plastic parts are marked for recycling
? Fluids (this can cause serious damage to the can now close the cover.back in place and close the vacuum cleaner
vacuum cleaner).upholstery nozzle (9). cover.purposes. For details see our web site: www.
About once each year, when the lter light electrolux.com
? Hot or cold ashes, lit cigarettes, etc.The suction power can be reduced by pressing
begins to ash more frequently, the lters need
? Fine dust, e.g. plaster, concrete, our.the Max-Min button on the vacuum cleaner or CleaningtheMaxInIf you have any comments on the cleaner or the
the Min button on the remote control.to be washed.andcarpet/DoornozzlesInstructions for Use booklet please e-mail us at:
The above can cause serious damage to the A Lift out the lters according to the above.
Frames,bookshelves,etc.:Use the dusting 40 The Max In and the carpet/oor nozzles
[email protected]
motor - damage which is not covered by the B Remove one lter at a time from the lter
brush (10).should be cleaned frequently to avoid
warranty.container (29) by pressing the marked If you cant ind accessories to your Electrolux
losing suction power. The easiest way to do
UsingMaxInnozzlesvacuum cleaner, please visit our website at www.
Power cord precautions:Max In, Max In Turbo and Max In motorised release button and turning the lter. this is by using the hose handle.electrolux.co.uk or call 08706 055 055.
? A damaged cord should only be replaced by an C Rinse the lters in lukewarm water and let 41 Remove the wheels and axles by pulling
oor nozzles, are ideal for both hard oors and
authorised Electrolux service centre. Damage them dry.them straight out. Remove dust-balls, hair
carpets. The Max In motorized nozzle receives
to the vacuum cleaner?s cord is not covered by D Thread the lters back into the lter holder.or anything else that may have got stuck.
power via the tube and hose, and no additional
the warranty.Cleaningtheexhaust|lter42 Use the crevice nozzle to clean the wheel
electrical connections are needed. A blue light
? Never pull or lift the vacuum cleaner by the on the nozzle indicates that the brush roller is There are two types of Electrolux Twinclean axles. Ret the wheels by pressing them
cord.exhaust lters:into place. The auxiliary wheels should The symbol on the product or on its
turning. If anything should become lodged in the packaging indicates that this product may not
? Disconnect the plug from the wall outlet ? Standard lter. Must be cleaned every 57 be carefully pulled straight out. Clean as
brush roller, the light turns o.be treated as household waste. Instead it shall
before cleaning the outside of the vacuum years.required and put them back in the reverse
be handed over to the applicable collection
cleaner. Note: Do not use the Max In Turbo or Max In ? HEPA lter (thicker with creased bre material). order.
point for the recycling of electrical and electronic
? Regularly check that the plug and cord are not motorised nozzles on fur rugs, rugs with long Must be cleaned every 23 years.
CleaningtheMaxInTurboequipment. By ensuring this product is disposed of
damaged. Never use the vacuum cleaner if the fringes or pile depths exceeding 15 mm. To avoid
cord is damaged.damaging the carpet, do not let the nozzle stay There is no dierence in how the lters are andmotorizednozzlescorrectly, you will help prevent potential negative
in one place when the brush is rotating. Do not cleaned or tted.Always unplug the vacuum cleaner from the wall consequences for the environment and human
All service and repairs must be performed by an 30 Remove the dust container by pressing the health, which could otherwise be caused by
pass the nozzle over electrical cords, and be sure outlet before cleaning.
authorised Electrolux service centre. Store the release button at the back of the vacuum
to switch of the vacuum cleaner immediately 43 To remove the brush roller cover, push the inappropriate waste handling of this product. For
vacuum cleaner in a dry space.cleaner and lifting the container.
after use.outer latch out, and the middle cover to the more detailed information about recycling of this
31 Lift the two snap catches at the back edge left, and this will also free the wheels for product, please contact your local city oice, your
Parkingposition
of the vacuum cleaner and open the lter cleaning.household waste disposal service or the shop where
19 When you pause during cleaning, the tube
cover.44 Lift out the brush roller and clean it. you purchased the product.
can be attached to the rear of the vacuum
32 Lift out the lter.Remove entangled threads etc. by snipping
cleaner.
them away with scissors. Ret in the
20 When storing, the vacuum cleaner can be
reverse order. The auxiliary wheels should
placed on end and the tube attached at the
be carefully pulled straight out. Clean as
bottom of the vacuum cleaner.
required and ret in the reverse order (45).
45
ACEC
