125981910.qxp 2006-02-03 08:25 Page 15
Clean it with a brush and rinse it under the shower ifThe reservoir must be re-inserted correctly.
necessary.
If this is not done the pilot light FULL TANK comes
on during next drying and the programme stops,
leaving the laundry damp. The buzzer will sound.
After inserting the reservoir the START/Add Clothes
button has to be depressed again to allow the
programme to continue.
Handy tip: The condensed water may be used in a
steam iron or to top up a battery, etc. In this case it
must be filtered (e.g. through a coffee filter).
Also clean the outside, removing all fluff.
Clean the rubber seal round the condenser cabinetCleaning the drum
and in the inner part of the small door with a damp
When your laundry does not reach the desired
cloth.
degree of dryness, in other words, when it turns out
Important! Do not use pointed objects or utensils to
either too dry or too damp,we advise you to clean
clean the spaces between the plates, as this could
the inside of the drum with a cloth soaked with
damage the condenser and make it permeable.
vinegar.
Re-fit the condenser, turn the red stops upwards
This will eliminate the slight patina that has formed
and close the door.
in the drum (due to residues of detergent and
softeners used in the washing, and to the lime
Do not use this appliance if the
contained in the water), which prevents the probes
condenser has not been fitted.
from detecting the correct degree of dryness.
Emptying the water reservoir
Water extracted from the laundry condenses inside
the machine and is collected in a reservoir.
The reservoir must be emptied after each drying
cycle to ensure efficient operation when the
machine is next used.
The FULL TANK light reminds you to perform this
operation.
Proceed as follows:
Pull out the reservoir
Turn it upside down and let water empty
Re-fit the reservoir
15 |
ACEC
