125985340_gb.qxp 2006-08-31 07:43 Page 11
use electrolux 11
programme is running, this buttonall the lights go out. The appliance is
must be pressed again after closingswitched off.
the door in order to restart the pro-Remove the laundry.
gramme from the point at which it wasIf you open and then close the doorGB
interrupted.before turning the selector dial to ?0? all
In both cases the light of thethe indicator lights come on.
Start/Pause button flashes to remind
AAfftteerr eeaacchh uussee
you that the start button needs to be
pressed again.
? Clean the filters.
IInnddiiccaattoorr lliigghhttss
Important!
These lights indicate the following
functions:If the drying programme has to be
stopped before it reaches the end, we
??DDrryyiinngg?? lliigghhtt
This light indicates that the appliance isrecommend that you turn the pro-
in the drying phase.gramme selector dial to position Cooling
??CCoooolliinngg?? lliigghhtt and wait until the end of this cooling
phase before removing the laundry. This
This light indicates that the appliance is
in the cooling phase. At the end ofwill avoid a build-up of heat inside the
drying, there is a 10 minute coolingappliance.To do this first turn the dial to
phase to cool the laundry.
?OO? and then to Cooling and depress
??EEnndd ooff pprrooggrraammmmee?? lliigghhtt Start button.
This light is on at the end of the cooling
phase, during the anti-creasing phase
and at the end of the programme.MMooddiiffyyiinngg tthhee pprrooggrraammmmee
??FFiilltteerr cclleeaanniinngg?? lliigghhtt To change a programme which is run-
ning, first cancel it by turning the pro-
It comes on every 80 cycles to remind
gramme selector dial to ?OO?. Select the
you that the condenser must benew programme and press the Start
cleaned.
button .
At the end of the programme
All drying programmes end with a 10
minute cooling phase.
If the laundry is not removed at the end
of the cycle, the dryer performs an
anti-creasing phase (duration: 30 min-
utes maximum).
If you do not remove the laundry, the
dryer will stop automatically at the end
of the anti-creasing phase.
Lights end and filter remain lit and the
buzzer sounds for 2 minutes.
Turn the programme selector dial to ?0?; |
ACEC
