ELECTROLUX EE600X Instruction Manual

Turn the knob clockwise for a finer texture
FIRST USE
and stronger coffee. Turn anticlockwise for
a coarser grind and weaker coffee.
FILL THE WATER TANK

- Open the unit clamping lock (ref.24) using the key PROGRAMMING THE QUANTITY
supplied. OF GROUND COFFEE
- Pull the coffee machine out of the unit on the
telescopic runners. - The machine is supplied already
- Fill the water tank (ref.27) located on the left-hand calibrated to supply the ideal dose of
side of the appliance with approx. 3 litres of water. ground coffee for a cup of espresso.
- Push the machine back into the unit and fasten the - However, the quantity of ground coffee
unit clamping lock. supplied can increased or decreased as
- Water hardness: follows:
place the filter holder (ref.20) with a one-
- before filling the water tank make sure that the
Brita filter is in place (see paragraph "Water cup filter (ref.21) below the coffee doser
supply"). outlet (ref.19) and press the grinder button
- if the appliance has not been used for a long time it (ref.18) gently, do not release the button
immediately. After approx. 10 seconds the
is advisable to replace the water in the tank with
fresh water and to empty the boiler by pressing the grinder will start, when the quantity
coffee button (ref.4) repeatedly. required is reached (recommended dose 7g
corresponding to 6 seconds of grinding)
simply release the button (ref.18) and the

FILL THE COFFEE BEAN HOLDER dosage is automatically programmed.


- Open the unit clamping lock (ref.24) using the key
PRELIMINARY START-UP
supplied.
- Pull the coffee machine out of the unit on the - Turn the coffee machine on by pressing the
telescopic runners. ON button (ref.3). The orange indicator
- Put approx. 200g of coffee beans into the coffee light (ref.8) lights up to indicate that the
bean holder (ref.26) on the right-hand side of the machine is powered.
appliance. - Turn the steam knob (ref.1) anti-clockwise.
- Push the machine back into the unit and fasten the - Press the hot water button (ref.5) and wait
unit clamping lock. until all the air in the boiler is released
through the steam spout (ref.16) and water
starts coming through.
ADJUSTING THE TEXTURE OF - The red indicator light (ref.9) lights up at
the same time to indicate that the water in
GROUND COFFEE
the boiler is being heated. When the red
indicator light goes out the water has
??The machine is supplied already calibrated to reached the required temperature for coffee
grind coffee beans to the ideal texture.
making.
??The texture of ground coffee can however be - Close the steam knob (ref.1) and release
adjusted using the grinding texture knob (ref.2). the hot water button (ref.5).

5