550
597
560
FO 2191
Fig. 15
Recess for the oven
? The opening for the oven must comply
with the dimensions given in the diagram
(Fig. 15).
? If the furniture unit is closed on the rear
side, an additional opening shall be
obtained onto the rear panel to allow the
gas and electrical connections and a
proper ventilation. This opening shall be
at least 200 x 300 mm wide.
Fixing the appliance to the
furniture unit
? The assembly including the built-in oven
and the gas burner support, which have
been fixed together in the factory to avoid
Fig. 16damage during the transport, must be
inserted into the cabinet recess. Once the
assembly is in place, it is possibile to
split the two parts and proceed with the? Open the oven door and secure it at the
installation of the gas burner support intoleft and right hand side with the supplied
the opening in the worktop (see followingscrews (Fig. 16).
paragraphs).
? When the oven is placed in the cabinet
Warning
recess and the gas hob installation has
been carried out, check that the oven isThe electrical connection cable and the gas
centred and secure it with the four woodconnection pipe should not come in con-
screws supplied within the accessory kit.tact with hot surfaces or squeezed.
52 |
ACEC
