CLEANING BETWEEN THE OUTER AND4. Tighten the screws positively with a Pozidrive
screwdriver before closing the oven door.
INNER DOOR GLASS
Do Not attempt to use the oven without the
glass being in place.
Under no circumstances should the door
assembly be detached from the product for
cleaning. Please refer to the cleaningIf the door glass panel becomes chipped or
instructions.has deep scratches the glass will be
weakened and must be replaced to prevent
the possibility of the panel shattering.
The outer door glass is removable for cleaning.Please contact your local Service Force
Centre who will be pleased to advise
further.
TO REMOVE THE OUTER GLASS
TO CLEAN THE INNER GLASS DOOR
1. Open the oven door slightly to gain access to the
PANELS
two cross head screws on the top of the oven
door.Clean the inner glass door panels using a soft cloth
and hot water to which a little washing up liquid has
2. Loosen the two screws using a Pozidrivebeen added. If the inner panel is heavily soiled, Hob
screwdriver.Brite may be used. Do not use abrasive cleaning
materials on the door glass. Ensure that all parts are
well rinsed and thoroughly dried before attempting to
replace the glass.
REPLACING THE OVEN LIGHT BULB
The type of bulb required is a 300°C 25 watt small
Edison Screw. Part number 572 491 5431-00/1
(Available through your local Service Force Centres).
CAUTION:DISCONNECT THE APPLIANCE
FROM THE ELECTRICITY SUPPLY BEFORE
REPLACING THE BULB.
3. Hold the door glass securely in place with oneOpen the door and remove the shelves and wirework
hand before removing the screws completely withrunners to enable easy access to the oven light
the other hand.assembly. Insert a flat blade screwdriver between
the oven side and glass which covers the bulb.
4. Using both hands, gently tilt the top of the door
glass towards you, lift slightly to disengage theSupport the glass with your hand and prise out
locators from the two bottom brackets.sufficiently to release the glass cover. Unscrew the
bulb in an anticlockwise direction until it is possible to
5. Clean the outer and inner glass using hot soapyremove the bulb with ease.
water or Hob Brite may be used with care. DO
NOT use Hob Brite on the Stainless Steel orFit the new bulb by turning in a clockwise direction
painted finishes. DO NOT try to clean the foiluntil it is secure. Ensuring the indent to the flange is
which is inside the door. The foil is there to helppointing to the rear of the oven, replace the glass by
pushing it firmly into the hole to cover the bulb
keep the door cool, if it is damaged it will notassembly.
work. Ensure that all parts are well rinsed and
thoroughly dried before attempting to replace theReplace the shelves and wirework runners. Restore
outer door.the electricity supply and adjust the time of day and
TO REPLACE THE OUTER GLASSclock as necessary.
1. Holding the oven glass with both hands, gently
place the locators into the holes of the brackets
at the bottom of the oven door.
2. Push the top of the oven glass towards the oven
door, ensuring the screw location holes line up.
3. Hold the glass in place with one hand and insert
the cross head screws into the location holes
with the other hand. Give the screws one turn to
ensure the glass is secure.
31 |
ACEC
