For replacement, use a 13amp BSI362 fuse. Only
Movable shelves
Electrical connectionsASTA or BSI approved fuses should be used.
The walls of the refrigerator have runners so that the
The plug must not be used if the fuse cover/carrier is
Any electrical work required to install this applianceshelves can be positioned as desired .
lost. The cover/carrier is indicated by the coloured
should be carried out by a qualified electrician or
insert at the base of the plug.For better use of space, the front half-shelves can lie
competent person.
over the rear ones.
A replacement cover/carrier must be obtained from
WARNING: THIS APPLIANCE MUST BE
your local Electrolux Service Force Centre.
EARTHED.
This appliance complies with the E.E.C. Directive
The manufacturer declines any liability should
No. 87/308 of 2.6.87 relative to radio interference
this safety measure not be observed.
suppression.
If the plug that is fitted to your appliance is notD338
This appliance complies with the following
suitable for your socket outlet, it must be cut off and
E.E.C. Directives:
the appropriate plug fitted.
- 73/23 EEC of 19.2.73 (Low Voltage Directive)
Remove the fuse from the cut off plug. Positioning the door shelves
and subsequent modifications;
The cut off plug should then be disposed of to
- 89/336 EEC of 3.5.89 (Electromagnetic
prevent the hazard of shocks in case it should beTo permit storage of food packages of various sizes,
Compatibility Directive) and subsequent
plugged into a 13amp socket in another part of yourthe door shelves can be adjusted in height.To make
modifications.
home.these adjustments proceed as follows:
Please ensure that when the appliance isGradually pull the shelf in the direction of the arrows
installed it is easily accessible for the engineer inuntil it comes off, then reposition as required.
Important
the event of a breakdown.
The wires in the mains lead are coloured in
accordance with the following code:
PR249
Green and Yellow - Earth
Blue - Neutral
Brown - Live
If you fit your own plug, the colours of the wires in
the mains lead of your appliance may not
correspond with the markings identifying the
terminals in your plug, proceed as follows:
GREEN & YELLOW
13 AMP. FUSE
PR250
13 AMP
BROWN
BLUE
CORD CLAMP
D207
Connect the Green and Yellow (earth) wire to the
terminal in the plug which is marked with the letter
�EE or the earth symbol or coloured green and
yellow.
Connect the blue (neutral) wire to the terminal in the
plug which is marked with the letter �NE or coloured
black.
Connect the brown (live) wire to the terminal in the
plug which is marked with the letter �LE or coloured
red.
The plug moulded onto the lead incorporates a fuse.
187 |
ACEC
