To change the light bulb
Before replacing the light bulb, disconnect the power
plug from the outlet.
Fold the grille backward by unsnapping the front
edge.
Use a bulb of the same type, E14 socket, maximum
ratingof 15W.
When the appliance is not in use
If the cabinet will be kept on, ask somebody to
Disconnect the appliance from electricity supply.check it once in a while to prevent the food inside
Empty all foods and clean the appliance, leaving thefrom spoiling in case of a power failure.
doors ajar to prevent unpleasant smells.
Something Not WorkingGB
Before contacting your local Service Force Centre check the following point:
ProblemPossible cause / Remedy
" " is displayed in the temperatureAn error has occurred in measuring the temperature. Call your
display.service representative. (The cooling system will continue to
keep food products cold, but temperature adjustment will not
be possible.)
It is too warm inside the wine cooler.Set a lower temperature.
Make sure that the door is completely closed and that the
insulating strip is complete and clean.
It is too cold inside the wine cooler.Set a warmer temperature.
There is water on the cooling plate insideThis is normal. During automatic defrosting, frost thaws on the
thewinecooler.cooling plate.
Water is running inside the wine cooler.Clean the water drain and drain hole inside the wine cooler
using e.g. cotton swabs or a bottle cleaner brush.
Some food products could have been placed near the rear of the
appliance prevetung the water from running into the drain.
Water comes out on the floor.Place the drain hose at the back of the cabinet above the drain
bowl. See the chapter "Before using the cabinet the first time".
The compressor operates continuously.Set a warmer temperature.
Make sure that the door is completely closed and that the
insulating strip is complete and clean.
The cabinet does not operate at all.The cabinet is not switched on.
Cooling or interior light does not
Power does not reach the cabinet. (Try connecting another
operate. No indicator lamps light.electrical device to the power outlet.)
The fuse has blown.
The power plug is not properly connected.
Sound level in cabinet is too high.The refrigerating system will always produce some sounds. A
Carefully follow the instructions in thepulsing sound is heard when coolant is pumped inside the
chapter "Installing the cabinet".cooling pipes. A ticking sound from the thermostat can be
heard when the compressor switches on and off. The sound
level varies depending on the operation of the cabinet.
If you feel the sound level is incorrect:
Make sure the pipes at the back of the cabinet not touch each
other. Carefully bend them if they do.
If the cushion spacers (between the cabinet wall and pipes)
come loose, put them back in place again.
Electrolux 818 35 03-00/5
7 |
ACEC
