Electrical connectionFitting a decor panel on the door
Before plugging the appliance into the wall socket, make sureThe door of this machine has frames for fitting a plastic
that:laminate decor panel in the colour required to match the
1.The mains voltage corresponds to the voltage given in the dishwasher with the rest of the kitchen furniture.
"Technical specifications".If you wish to do this you must provide the panel yourself, that
must have the following dimensions:
2.The meter, fuses, mains power supply and wall socket can
all take the maximum load required.Width:588 mm
Make sure that the socket and plug are compatible without Height:586 mm
having to use any type of adaptor. If necessary, have the Max thickness:4 mm
domestic wiring system socket replaced.
To fit the panel
Important:The plug must still be accessible after the- Take the door frame off after removing the retaining screws
appliance has been installedaround the edge.
Safety standards require the appliance to be
earthed.- Position the panel, refit the frame and tighten the retaining
The manufacture accepts no liability for failure to observescrews around the edge.
the above safety precautions.
Fitting under a counter
(kitchen worktop or sink)
By removing the machines worktop, you can install it under a
close fitting sink unit or a pre-existing top, providing the
dimensions of the recess correspond to those shown in the
picture.AP01
Proceed as follows:
Note:570 - 600
- Remove the machines The panel should be fitted before positioning the machine.
worktop by unscrewing
the two rear retaining
screws, pull from the front 820
and slide out the rear
slots, lifting the worktop.600
IN05
Insert the machine after adjusting height and levelling with the
adjustable feet. When inserting the machine, ensure that the
water inlet and drain hoses are not kinked or squashed.
Levelling
Good levelling is essential for correct closure and sealing of
the door.
When the appliance is correctly levelled, the door will not catch
on the levelling spacers on either side of the cabinet.
If the door does not close correctly, loosen or tighten the
adjustable feet until the machine is perfectly level.
15 |
ACEC
