Attention: keep ventilation openings clear of
obstruction.Environment Protection
nIf the appliance is transported horizontally, it is
possible that the oil contained in the compressornThis appliance does not contain gasses which
flows in the refrigerant circuit. It is advisable tocould damage the ozone layer, in either its
wait at least two hours before connecting therefrigerant circuit or insulation materials. The
appliance to allow the oil to flow back in theappliance shall not be discarded together with
the urban refuse and rubbish. Avoid damaging
compressor.the cooling unit, especially at the rear near the
nThere are working parts in this product which heatheat exchanger. Information on your local
up. Always ensure that there is adequate
ventilation as a failure to do this will result indisposal sites may be obtained from your
component failure and possible food loss. Seemunicipal authorities.
installation instructions.nThe materials used on this appliance marked
with the symbol are recyclable.
nParts which heat up should not be exposed.
Wherever possible the back of the product should
be against a wall.
nIf the appliance has been transported horizontally,
it is possible that the oil contained in the
compressor flows in the refrigerant circuit. It is
advisable to wait at least two hours before
connecting the appliance to allow the oil to flow
back in the compressor.
DESCRIPTION OF THE APPLIANCE
AAir outlet duct
�Freezer controls
�Air inlet filter�
AComparments for storing frozen food
�Compartments for freezing fresh food�
A
A
��A
4 |
ACEC
