ProblemPossible cause
Y The door will not open:Y The programme is still running.
ENGLISH
Y The door lock has not been released.
Y Spinning starts late or theY The electronic unbalance detection device has cut in
because the laundry is not evenly distributed in the
machine does not spin:
drum. The laundry is redistributed by reverse
rotation of the drum. This may happen several times
before the unbalance disappears and normal
spinning can resume. If, after 10 minutes, the
laundry is still not evenly distributed in the drum, the
machine will not spin. In this case, redistribute the
load manually and reselect the spin programme.
Y The machine makes anY The machine is fitted with a type of motor which
makes an unusual noise compared with other
unusual noise:
traditional motors. This new motor ensures a
softer start and more even distribution of the
laundry in the drum when spinning, as well as
increased stability of the machine.
Y Machines based on modern technology operate
Y No water is visible in the
very economically using very little water without
drum:
affecting performance.
Y Too little detergent or unsuitable detergent has
Y Unsatisfactory washing
been used.
results:
Y Stubborn stains have not been treated prior to
washing.
Y The correct temperature or programme was not
selected.
Y Excessive laundry load.
Y This is most problaby due to non soluble
Y Detergent residue is left after
components contained in modern detergents. It is
the wash cycle:
not a sign of inadequate rinsing.
Brush or shake the garments and, if necessary,
wash them again.
Y Modern detergents can produce foam even after
Y Foam remains after the last
rinsing, but this will not affect the quality of the
rinse:
wash.
If you are unable to identify or solve the problem,
Mod...........Ser.
contact our service centre. Before telephoning,
make a note of the model, serial number and
purchase date of your machine: the Service Centre
will require this information.
Mod. ..........
Prod. No. ...........
Ser. No. .........
P0042
21 |
ACEC
