132996950.qxd 12/10/01 13.42 Pagina 7 (Nero/Process Black pellicola)
Installation
UnpackingPositioning
Install the machine on a flat hard floor.
All transit bolts and packing must be removed
Make sure that air circulation around the machine isENGLISH
before using the appliance.
not impeded by carpets, rugs etc. Check that the
machine does not touch the wall or other kitchen
You are advised to keep all transit devices so that
units.
they can be refitted if the machine ever has to be
Carefully level by screwing the adjustable feet in or
transported again.
out. Never place cardboard, wood or similar
1. Using a spanner, unscrew and remove the rear
materials under the machine to compensate for any
right-hand bolt and lay the machine on its back,
unevenness in the floor.
taking care not to squash the hoses. This can be
avoided by placing one of the corner packing
pieces between the machine and the floor.
Water inlet
Connect the water inlet hose, supplied with the
2. Remove the polystyrene block from the underside
machine, to a tap with a 3/4" thread. Do not use
of the machine and release the two plastic bags.
already employed hoses.
3. Carefully remove the right-hand bag (1) then the
The other end of the inlet hose which connects to the
left-hand bag (2) by pulling them towards the
machine can be turned in any direction. Simply
centre of the machine.
loosen the fitting, rotate the hose and retighten the
fitting, making sure there are no water leaks
4. Set the machine upright and remove the two
remaining bolts from the back.
5. Pull out the three plastic spacers from the holesThe inlet hose must not be lengthened. If it is too
into which the bolts were fitted.short and you do not wish to move the tap, you will
have to purchase a new, longer hose specially
6. Plug the open holes with the plugs which you will
designed for this type of use.
find in the envelope containing the instruction
booklet.
7 |
ACEC
