? Remove any objects from the pump impeller by
rotating it.6. Emergency emptying out
If the water is not discharged, proceed as follows to
empty out the machine:
? pull out the plug from the power socket;
? close the water tap;
? if necessary, wait until the water has cooled down;
ENGLISH? open the pump door;
? place a bowl on the floor and place the end of the
emergency emptying hose into the bowl. Remove
its cap. The water should drain by gravity into the
? Put the cap back on the emergency emptying hosebowl. Whe the bowl is full, put the cap back on the
hose. Empty the bowl. Repeat the procedure until
and place the latter back in its seat.water stops flowing out;
? clean the pump if necessary as previously
described;
? replace the emergency emptying hose in its seat
after having plugged it;
? screw the pump cover again and close the door.
7. Frost precautions
If the machine is installed in a place where the
? Screw the pump cover fully in.temperature could drop below 0°C, proceed as
? Close the pump door.follows:
? Remove the plug from the socket.
? Close the water tap and unscrew the water inlet
5. Water inlet filterhose from the tap.
If you notice that the machine is taking longer to fill,
check that the filter in the water inlet hose is not? Place the end of the emergency emptying hose
and that of the inlet hose in a bowl placed on the
blocked.floor and let water drain out.
Turn off the water tap.? Screw the water inlet hose back on and reposition
Unscrew the hose from the tap.
the emergency emptying hose after having put the
Clean the filter with a stiff brush.cap on again.
Screw the hose back onto the tap.By doing this, any water remaining in the machine is
removed, avoiding the formation of ice and,
consequently, breakage of the affected parts.
When you use the machine again, make sure that
the ambient temperature is above 0°C.
2323
11-25 ES Mac64.indd 23-25 ES Mac64.indd 2333/4/06 12:45:49 AM/4/06 12:45:49 AM |
ACEC
