132992810gb.qxd 04/09/2003 09:41 Pagina 6
The inlet hose must not be lengthened. If it is tooElectrical connection
short and you do not wish to move the tap, you will
have to purchase a new, longer hose speciallyThis machine is designed to operate on a 220-230
designed for this type of use.V, single-phase, 50 Hz supply.
Check that your domestic electrical installation can
take the maximum load required (2.2 kW), also
Water drainagetaking into account any other appliances in use.
The end of the drain hose can be positioned in threeConnect the machine to an earthed socket.
ways:
Hooked over the edge of a sink using the plasticThe manufacturer declines any responsibility
hose guide supplied with the machine. In thisfor damage or injury through failure to comply
case, make sure the end cannot come unhookedwith the above safety precaution.
when the machine is emptying.Should the appliance power supply cable
This could be done by tying it to the tap with a pieceneed to be replaced, this should be carried
of string or attaching it to the wall.out by our Service Centre.
The power supply cable must be easily
accessible after installing the appliance.
In a sink drain pipe branch. This branch must be
above the trap so that the bend is at least 60 cm
above the ground.
Directly into a drain pipe at a height of not less
than 60 cm and not more than 90 cm.
The end of the drain hose must always be
ventilated, i.e. the inside diameter of the drain pipe
must be larger than the outside diameter of the drain
hose.
The drain hose must not be kinked. Run it along the
floor; only the part near the drainage point must be
raised.
6 |
ACEC
