Interior light
CUSTOMER SERVICE AND SPARE PARTS
The light bulb inside the refrigerator compartment
can be reached as follows:
If the appliance is not functioning properly, checkopening is not obstructed (see ODefrosting�
that:section).
- unscrew the light cover securing screw.
Y If your appliance is still not working properly after
- unhook the moving part as shown in the figure.Y the plug is firmly in the wall socket and the mains
power switch is on;making the above checks, contact the nearest
service centre.
Y there is an electricity supply (find out by plugging
If the light does not come on when theTo obtain fast service, it is essential that when you
in another appliance);
door is open, check that it is screwed into placeapply for it you specify the model and serial number
Y the thermostat knob is in the correct position.
properly. If it still does not light up, change theof your appliance which can be found on the
bulb. The rating is shown on the light bulb cover.Y If there are water drops on the bottom of theguarantee certificate or on the rating plate located
D411cabinet, check that the defrost water draininside the appliance, on the bottom left-hand side.
Defrosting
INSTALLATION
Frost is automatically eliminated from the evaporator
of the refrigerator compartment every time the motor
compressor stops, during normal use. The defrostLocation
Building-in instructions
water drains out through a trough into a special
The appliance should be installed well away from
container at the back of the appliance, over theFor safety reasons, minimum ventilation must be as
sources of heat such as radiators, boilers, direct
motor compressor, where it evaporates.shown in Fig.
sunlight etc.
It is important to periodically clean the defrostAttention: keep ventilation openings clear of
water drain hole in the middle of the refrigeratorobstruction.
Electrical connection
compartment channel to prevent the water
It is necessary that the niche is provided with a
overflowing and dripping onto the food inside.Before plugging in, ensure that the voltage and
D037conduct of ventilation having the following
Use the special cleaner provided, which you willfrequency shown on the serial number plate
dimensions:
find already inserted into the drain hole.correspond to your domestic power supply. Voltage
Depth 50 mm
The freezer compartment, however, will becomecan vary by ?6% of the rated voltage.
Width 540 mm
progressively covered with frost. This should beFor operation with different voltages, a suitably sized
removed with a plastic scraper , whenever theauto-transformer must be used.
thickness of the frost exceeds 4 mm. During this
The appliance must be earthed.
operation it is not necessary to switch off the power
supply or to remove the foodstuffs.The power supply cable plug is provided with a
contact for this purpose.
However, when the ice becomes very thick on the
inner liner, complete defrosting should be carried outIf the domestic power supply socket is not earthed,
and it is advisable to carry out this operation whenconnect the appliance to a separate earth in
the appliance is empty.compliance with current regulations, consulting a
PR151specialist technician.
To carry out complete defrosting of the freezer
compartment proceed as follows:The Manufacturer declines all responsibility if
the above safety precautions are not observed.
1. pull out the plug from the wall socket or turn the
This appliance complies with the following
thermostat knob to the �OE setting;
E.E.C. Directives:
2. remove any stored food, wrap it in several layers
of newspaper and put it in a cool place;- 87/308 EECof 2/6/87 relative to radio interference
3. leave the door open, place a basin on the topsuppression.
Important:
shelf of the refrigerator compartment under the
- 73/23 EECof 19.2.73 (Low Voltage Directive) and
drain hole, remove the plugas shown in theNever use sharp metal tools to scrape off frostsubsequent modifications;
figure;
from the evaporator as you could damage it.
- 89/336 EECof 3.5.89 (Electromagnetic
4. when defrosting is completed, dry the interior
Do not use a maechanical device or any artificialCompatibility Directive) and subsequent
thoroughly and refit the plug;
means to speed up the thawing process othermodifications.
5. turn the thermostat knob back to the required
than those recommended by the manufacturer.
setting or replace the plug in the power socket.
A temperature rise of the frozen food packs,
After letting the appliance run for at least half an
ATTENTION!
during defrosting, may shorten their safe
hour, replace the previously removed food into
storage life.It must be possible to disconnect the appliance from
the compartment.
the mains power supply; the plug must therefore be
easily accessible after installation.
1819 |
ACEC
