Installing your television set(Diagrams are for illustration only.
May differ from actual TV sets)
Positioning the television setRemote control
10 cm
10 cm10 cm
Insert the two R6-type batteries (supplied)
Place your TV on a solid, stable surface,making sure that they are the right way
round.
leaving a space of at least 10 cm around theThe batteries supplied with this appliance do
appliance.
not contain mercury or nickel cadmium.
If you have access to a recycling facility, please do
Connectionsnot discard your used batteries (if in doubt,
consult your dealer).
Switching on
Y Insert the aerial plug into the x socket
at the rear of the set.
If you are using an indoor aerial, reception
may be difficult in certain conditions. You
To switch on the set, press the on/off key.
can improve reception by rotating the
aerial. If the reception remains poor, youA red indicator means that the television is on
standby mode. Refer to the next page on �Remote
will need to use an external aerial.Control keysO for the various keys that you could
Y Insert the mains plug into a wall socket.use to switch on the set An indicator light will
flash when it is receiving signal from the remote
Diagram may differ from the actual plug.control.
The keys on the TV set
The television set has 4 keys which areThe VOLUME increase/decrease key is used
located at the top/or front.to adjust the sound levels. The CHANNEL
up/down key is used to select channels.
To access or exit the main menu, press down
the VOLUME increase/decrease keys,
simultaneously.
To select an item in the main menu, press the
CHANNEL up/down key.
To select an adjustment, press down the
VOLUME increase/decrease key.
Installation Operating instruction 3
p3-7312/28/04, 10:52 AM |
ACEC
