AZ 1040 /00 page 6
BASIC FUNCTIONSGENERAL INFORMATION
EnglishSwitching on and off
Y Adjust the POWER slider to the desired sound source: CD,
TUNER or TAPE.
Y The set is switched off when the POWER slider is in theOFTTFUAPNEERCD
RPOWE
DBBCD R
TAPE/OFF position and the keys on the tape deck areSS BOOSTDYNAMIC BA
PAUSE
TOP-OPENS
released.HSEARC
P
" The tuner presets will be retained in the set's memory.UME+
Adjusting sound and volume
CD
1. Turn VOLUME to the desired level.DBBPOWEROFTTFUAPNEER
DYNAMIC BA
2. Adjust the DBB control to select dynamic bass boost on or off.SS BOOSTPAUSESTOP-OPEN
+
UME
-VOL
CDSHUFFLE
PHILIPS demo mode
1. Press the CD STOP 9 button for 5 seconds.
CDSHUFFLEALL
" After about 30 seconds, PH..IL ..IPS scrolls across the display.ER
PRESETTDIGUNITAL
2. To return to the current display you can either:MODE
Y press any function button on the front panel. This interruptsPLAYYPAUSEPROGBLAOTWT
STOP
the demo mode for 30 seconds;SEARCH
Y press the CD STOP 9 button for 5 seconds. PH..IL ..IPS
scrolls once before the demo mode is cancelled.
GENERAL INFORMATION
General maintenance
Y Do not expose the set, batteries, CDs or cassettes to humidity,
rain, sand or excessive heat caused by heating equipment or
direct sunlight.
Y To clean the set, use a soft, slightly dampened chamois
leather. Do not use any cleaning agents containing alcohol,
ammonia, benzene or abrasives as these may harm the
housing.
Safety information
Y Place the set on a hard and flat surface so that the system
does not tilt. Make sure there is adequate ventilation to
prevent the system from overheating.
Y The mechanical parts of the set contain self-lubricating
bearings and must not be oiled or lubricated.
6 |
ACEC
