XP AZ 1120/00-1 22-06-2000 15:08 Pagina 11
AZ 1120 /00 page 11
TROUBLESHOOTING
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
EnglishWARNING: Do not open the set as there is a risk of electric shock! Under no
circumstances should you try to repair the set yourself, as this would
invalidate the warranty.
PROBLEMThe CD skips tracks
� POSSIBLE CAUSE� CD is damaged or dirty
Y REMEDYY Replace or clean the CD
� SHUFFLE or PROGRAM is active
No sound/powerY Quit SHUFFLE/PROGRAM mode(s)
� VOLUME is not adjusted
Y Adjust the VOLUMEPoor cassette sound quality
� Headphones connected� Dust and dirt on the heads, etc.
Y Disconnect headphonesY Clean deck parts etc., see Maintenance
� Mains lead not securely connected� Use of incompatible cassette types (METAL
Y Connect AC mains lead properlyor CHROME)
� Batteries exhausted/ incorrectly insertedY Only use NORMAL (IEC I) for recording
Y Insert (fresh) batteries correctly
Recording does not work
Display does not function properly/ No� Cassette tab(s) may be broken
reaction to operation of any of the controlsY Apply a piece of adhesive tape over the
� Electrostatic dischargemissing tab space
Y Switch off set, disconnect the mains plugRemote control does not function properly
and reconnect after a few seconds� Batteries exhausted/ incorrectly inserted
CD playback does not workY Insert (fresh) batteries correctly
� CD is badly scratched/ dirty� Distance/ angle between the set too large
Y Replace/ clean CD (see maintenance)Y Reduce the distance/ angle
� Laser lens steamed up
Y Wait until lens has acclimatized
This product complies with the radio interference requirements
of the European Community
The type plate is located on the bottom of the set.
11 |
ACEC
