Operating sequence
1. Check the filters 9. At the end of the washing
Ensure they are clean and properly positioned programme
(see "Maintenance and cleaning").At the end of the programme the dishwasher will
automatically stop.
2. Check that there is rinse aid and
salt 10.Switch off the dishwasher
Switch off the dishwasher by pressing the On/Off
push button and open the door.
W ait a few minutes before removing the dishes;in
3. Load the dishes
this way they will be cooler and the drying will be
Remo ve any scraps of food.improved.
Pull the lower basket out and arrange the
Empty the lower basket first and then the upper one;
saucepans, plates and cutlery in it.this will avoid water dripping from the upper basket
Pull the upper basket out and arrange the plates, onto the dishes in the lower one.
saucers, glasses and cups etc.in it.
Slide the baskets back into the machine.
When the washing programme has finished,it
is recommended that the dishwasher is
unplugged and the water tap turned off.
4. Ensure that the spray arms can
rotate freely.In general it is not advisable to open the door
while the machine is working;if the door is
opened however,a safety device ensures that
the machine stops.
5. Measure out detergent
Add the required amount of detergent into the
dispenser according to the "Washing programmes"
chart.Important!
Care must be taken if the door is opened during
Close the detergent dispenser lid.the hot phase or immediately after a
programme has finished,as steam may escape.
6. Ensure that the spray arms can
rotate freely.
7. Set the programme
Turn the programme selector dial clockwise until the
letter of the programme you wish to select
corresponds with the programme marker on the
control panel.
If necessary select the temperature of the main
wash according to the instructions in the "Washing
programmes" chart (see "Required push buttons").
8. Start the programme
Depress the On/Off push button.
The On/Off indicator light will come on and the
machine will start.
25 |
ACEC
ELECTROLUX
