If after all these checks, the problem persists, contact your
Protection against flooding
local Authorised Service Centre, quoting the model (Mod.), the
PNC number and the serial number (S.N.). In order to prevent water floods, the machine has been
provided with two devices, having the following characteristics:
This information can be found on the rating plate located on
the right hand side of the dishwasher door (see picture).1.In the water inlet hose (see "Water supply connections").
So that you always have these numbers at hand, weThe device comes into operation as a result of any damage
recommend you to make a note of them here:to the water inlet hose and stops the water inflow.
To repair the machine call the Authorised Service Centre.
Mod.: . . . . . . . . . . . . . . . . .
PNC: . . . . . . . . . . . . . . . . . 2.In the bottom of the machine:
S.N.: . . . . . . . . . . . . . . . . . The device comes into operation as a result of any water
leaks in the machine.
In case of intervention in the digital display AL4.will appear
To repair the dishwasher, turn off the water tap and call the
Authorised Service Centre.
RA08
Service and spare
parts
This product should be serviced by an authorised Service
engineer, and only genuine spare parts should be used.
Under no circumstances should you attempt to repair the
machine yourself.
Repairs carried out by inexperienced persons may cause
injury or serious malfunctioning. Contact your local
Authorised Service Centre.
Always insist on genuine spare parts.
Installation instructions
Any electrical work required to install this applianceFor making the connection itself, the coupling nut fitted to the
should be carried out by a qualified electrician ormachines supply hose is designed to screw onto either a 3/4
competent person.inch gas thread spout, or to a purpose made quick-coupling
tap such as the Press-block.
Any plumbing work required to install this appliance
should be carried out by a qualified plumber or competentDo not use, for connection, old hoses which have been
person.used in another appliance.
Remove all packaging before positioning the machine.
The water supply hose is fitted with a safety device, which
If possible, position the machine next to a water tap and a
prevents water from entering the machine should the inner
drain.
hose split, due to wear.
Attention!
The problem is signalled by a red indicator which appears in
Carefully follow the instructions on the enclosed template forthe window B (- ? ?).
building in the dishwasher and fitting the furniture panel.
The retaining Aring - ? ?() must be properly fitted so as to
avoid water leaks.
Water supply connections
This dishwasher may be fed with either hot (max. 50°) or cold
water. Nevertheless we advise you a cold water supply.
A hot water supply is not always efficient with very soiled
crockery as it shortens the washing programmes a lot.
A
The water pressure must be within the limits given in the2
1
technical specifications. BA
C
Your local Water Authority will advise you on the averageB
mains pressure in your area.
CA13
The dishwasher features fill and drain hoses which can be
turned either to the left or the right to suit the Note:installation. The
locknut must be correctly fitted to avoid water leaks. Only for water supply hoses fitted with Lock-fast safety device
Avoid bends or kinks in the hose which could prevent or slowto prevent inadvertent loosening.
down the water supply. To detach the hose press yellow C - ?lever ) and (turn the
If the machine is connected to new pipes or pipes which haveretaining ring anticlockwise ? .
not been used for a long time, you should run the water for a
few minutes before connecting the inlet hose. This will prevent
deposits of sand or rust clogging the inlet hose filter.
15 |
ACEC
ELECTROLUX
