Before use
Before using your dishwasher for theFilling with salt
first time:
Only use salt specifically designed for use in
1.Ensure that the electrical and water connections comply dishwashers.
with the installation instructionsAll other types of salt not specifically designed for use in
2.Remove all packaging from inside the appliancea dishwasher, especially table salt, will damage the water
softener.
3.Set the water softener
Only fill with salt just before starting one of the complete
4.Pour 1 litre of water inside the salt container and then fill
washing programmes. This will prevent any grains of salt
with salt
or salty water, which may have been spilled, remaining on
5.Fill the rinse aid dispenser.the bottom of the machine for any period of time, which
6.Run a "Rinse and Hold" programme.may cause corrosion.
Setting the water softenerTo fill:
The dishwasher is equipped with a water softener designed to1.To fill with salt, unscrew the cap of the salt container.
remove minerals and salts from the water supply, which would
2. Pour 1 litre of water inside the container (this is
have a detrimental or adverse effect on the operation of the
necessary only before filling with salt for the first time).
appliance.
The higher the content of these salts, the harder your water is.3.Using the funnel provided,
pour in the salt until the
Water hardness is measured in equivalent scales, Clarke,
SALE
container is full.
French degrees and PPM (parts per Million).SALT
Do not worry if water over SALZ
SEL
The softener should be adjusted according to the hardness of
flows from the unit when
the water in your area. Your local Water Authority can advise
filling with salt, this is quite
you on the hardness of the water in your area.
normal.
The dishwasher is factory set at level 2.
4.Replace the cap making
If this level is not suitable for your area the softener should besure that there is no trace
adjusted.of salt on the screw thread
SR06
or on the gasket.
Water hardness
5.Screw on the cap tightly.
ClarkeFrenchPPM
degrees degrees(Parts perLevelUse of
(°TH)Million)The salt container will require topping up periodically. salt
0 - 60 - 80 - 800NO
The salt cap has a refill indicator window in the centre.
7 - 149 - 2081 - 2001YESA green floatis clearly visible when there is salt inside the
container, and almost disappears when the salt has finished
15 - 2821 - 40201 - 4002YES
reminding you to add salt.
29 - 4241 - 60401 - 6003YES
43 - 5661 - 80601 - 8004YES
57 - 6381 - 90801 - 9005YES
If your water is level 0 it is already soft and therefore there
is no need to use salt.
In this case adjust the water softener on level 1 without
using salt.
SR11
To adjust the water softener
With a screwdriver turn the selector on the upper front corner
of the machine until the level required corresponds with the
marker.
34
25
21
AA05
5 |
ACEC
ELECTROLUX
