3. INSTALLATION3.3. Moving your washing machine
If you want to move your washing
3.1. Unpacking
machine, lift it onto its rollers by pul-
Packing used to protect internal parts of the washingling the lever at the bottom of the
machine during transport must be removed before thewashing machine all the way to the
washing machine is put into service for the first time.left. When you have put your
washing machine into the required
Remove all packing from thelocation, put the lever back into its
washing machine. Tilt the washinginitial position.
machine sideways and then remove
the packing under the motor, and3.4. Leveling
straighten the washing machine.
Precise leveling will prevent vibrations, noise and move-
ments of the washing machine during operation.
Make the washing machine level by
Tilt the washing machine back-adjusting the leveling screw that is
wards, rotate it by a quarter of a turntoo short. Unscrew the stand and
on one of its corner to remove thelocking collar assembly (lift the
transport base.washing machine if necessary).
When the washing machine is sta-
ble, maintain the stand on the
ground and turn the locking collar as
Open the washing machine lid andfar as posible.
remove the immobilization packing3.5. Water inlet
and plastic films.Please install the water inlet hose onto the back of your
Close the lid.washing machine:
- Insert the seal in the hole at the bot-
tom of the back panel (fig. 1).
Use a 10 mm spanner to remove the- Screw on the bottom fitting of the
two screws and spacers at the back.water inlet hose as shown in fig. 2
and fig. 3.
- Connect the feed hose connector
onto the water inlet tap, taking care to
position the gasket correctly.
You can now see the openings that- Turn on the water inlet tap.
must be closed with the caches in the
pack attached to the washing machi-
ne; do not forget to fold down theThe water inlet hose cannot be exten-
ded. If it is too short, please contact
central capsule.the After Sales Department.
3.6. Drainage
Make sure that you have removed all- Assemble the hose holder onto the
drain hose.
these parts from your washing ma-- Place the assembly in a drainage
chine and keep them so that you canpipe (or in a sink) at a height between
use them again if you need them for
future transport.70 and 100 cm. Make sure that it will
not fall out.
You must provide an air intake at the
end of the drainage hose, to avoid
If you want to keep your washing ma-
any water being siphoned.
chine aligned with the adjacent furni-Important: the drainage hose must not be extended, on any
ture, you can cut the pipe supportaccount. If it is too short, contact a qualified engineer.
strip at the back of your washing ma-
chine. Leave the two side closers in
3.7. Electrical connection
place.
You can only connect this washing machine to 230 V single
phase power supply.
Check rating of the fuse line: 10 A at 230V.
3.2. Position
Put the washing machine on a flat hard floor in a well venti-The washing machine must not be connected through an
extension cable or a power bar.
lated room.Check that the earthing connection is conform with the regu-
Make sure that your washing machine does not touch thelations in force.
wall or any other furniture in the room.
2 |
ACEC
ELECTROLUX
