ProblemPossible causeRemedy
Select time programme or higher drying
Drying cycle ends shortly after Not enough washing loaded or
level (e.g. INTENSIVE DRY [STARK
programme starts. END washing loaded is too dry for select-
TROCKEN] instead of STORAGE DRY
(ENDE) display illuminated.ed programme.
[SCHRANK TROCKEN]).
Lint filter clogged.Clean lint filter.
Drying cycle lasts an unusual-Heat exchanger clogged with lint.Clean heat exchanger.
ly long time.
SPECIAL CARE (SCHON) button SPECIAL CARE (SCHON) is only suita-
Note:
pressed and load volume too big.ble for use with loads of up to 3kg!
After up to 5 hours the drying
cycle finishes automaticallyLoad volume too big.Reduce load volume.
(see ?Drying cycle complete?).
Laundry must be adequately pre-
Laundry insufficiently pre-drained.
drained.
Changing bulb for inside
light
Only use a special bulb which is designed specially
for dryers. The special bulb is available from the af-
ter-sales service,
ET-Nr. 112 552 000-5.
1Warning! Do not use standard bulbs! These
develop too much heat and may damage the
machine!
1Warning! Before replacing the bulb, discon-
nect the mains plug; with a permanent con-
nection: fully unscrew or deactivate the fuse.
1.Unscrew covering bonnet from above bulb (this
can be found directly behind the loading aperture,
at the top; refer to ?Description of machine? sec-
tion.)
2.Replace defective bulb.
3.Screw covering bonnet back down.
1Warning! For reasons associated with safety,
the covering bonnet must be screwed down
tightly. If this is not done, the dryer must not
be operated.
19 |
ACEC
